SMC Networks 1560 user manual Cable Requirements

Page 40

Appendix D — Mounting & Cabling

Contents

Cable Requirements

SCANport cables are available in either Male to Male or Male to Female configurations. Cables of up to 10 meters (33 feet) can be connected from the SCANport device to the 1560-MBP. If a Port Expander is used, the cable length from the master to the Port Expander must be subtraced from the cable length used to connect the device to the expander (B1 + C = max 10 meters).

Generally when selecting a SCANport cable, the Male-Male configuration will be used. This is true in all cases when connecting to Ports 2 through 5. If connecting to the HIM port (Port 1) the Male-Female cable will be required.

Please verify with the Installation Manual for the A–B device the correct cable configuration. The following drawing, excerpted from A-B document 1203-5.2, is an example for a 1305 drive installation.

1305 Drive
						Port Expander
						Port Expander
			Port 2
Port 1			Port 2		2 3 4 5
Port 1			C		2 3 4 5					B

							Optional
							Optional
							Male-Female
							Cable
				B

A

Optional

Male-Female

Cable

Human Interface Module

40

Image 40

Contents 1560 Table of Contents Please Read This Notice Quick Start Guide Step-by-StepRevisions Product Specifications Modbus Plus SpecificationsGeneral Specifications Configuration via dip switches Slave Address Host Address24 VDC Operating Temp To 50 C Storage Temp 40 to 85 C Modbus Plus Port Functionality Supported Mstr Programming CommandsModbus Plus Communications Mstr Type 5 Write Global Data Modbus Register MapMBP Modbus Address Space 1560-MBP Card Setup Connecting Power to the 1560-MBP Card Hardware SetupDip Switch Configuration Switch SW Function Description Details Fault on LossModbus PlusSwitch SW 2 cont’d Contents Writing to the 1560-MBP Global Data Enabled Mstr Type Programming Considerations1560-MBP Global Data Enable 40400 Active Abort Error 40410Modicon Programming Example Mstr SuccessHost Issued Write Commands Mstr Type Global Data Mstr Type Reading from the 1560-MBPModicon Programming Example Mstr Type Host Issued Read Commands Mstr Type Enable 40500 Active40510 0001040060 4005000020 MBP Status Registers 40021 to Modbus Name Values Description AddressBatch At this time LED Troubleshooting Table TroubleshootingLED Locations SCANport Mbpstat Diagnostics Cable Diagram TxRxD+Technical Support Technical Support ContactsMBP Modbus Register Map Appendix aMBP Modbus Appendix B Device Specific HintsLogic Control Word Bit Function Description Setting up the Adaptor I/O DataDrive Status Word Bit Function Description Hardware Configuration Appendix CSingle Drive Peer Cop Application Example OverviewSwitch Position Description Configuration Extension BlocksPLC REF Drive Status RefOffset Description Ladder Logic ProgrammingPLC Ref PLC Name Description Special Precautions and hints TimingAddressing HintsAppendix D Mounting and SCANport Cabling InstructionsMounting Instructions 70mmCable Requirements Appendix E SCANport Datalink OperationService and Repair Repair and WarrantyGeneral Warranty Policy Hardware Product Warranty Details Limitation of LiabilityContents