Resident Disconnect Sequence or wait for the Timeout Period to elapse (if enabled).
Availability: Supervisor Only
Format: /D[/Y] <x> [x] [Enter]
Where:
/Y (Optional) suppresses the "Sure?" prompt.
xIs the number or name of the port(s) to be disconnected. To Disconnect all ports, enter an asterisk. To disconnect the Network Port, enter an "N".
Response:
Verbose: "Are you Sure (y/n)?", if Y, unit will respond with "Disconnected".
Terse: 5, if Y, unit will respond with 3.
Example: To disconnect Port 2 from Port 3 without the "Sure?" prompt, access the Command Mode from a third port with "All" command capability and type one of the following commands:
/D/Y 2 [Enter] or /D/Y 3 [Enter]
/E Erase Buffer
Erases data from the buffer for a specified port or several ports. Note that erased data cannot be recovered.
Availability: Supervisor Only
Format: /E[/Y] <x> [x] [Enter]
Where:
xIs the number or name of the port buffer(s) to be cleared. To erase buffers for all ports, enter an asterisk.
/Y (Optional) Suppresses the "SURE? (Y/N)" prompt.
Response:
Verbose: "Are You Sure (y/n)?", if Y, the unit will respond with "OK".
Terse: 5, if Y, the unit will respond with 0.
Example: To clear the buffer for Port 3, access the Command Mode from a port with "All" command capability, and type /E 3 [Enter].
/F Set System Parameters
Displays a menu which is used to define the Site ID message and Supervisor Password. When the Supervisor Password is defined, the CMS will display a password prompt before allowing