Lantronix XN manual To Configure Tunnel Packing Mode Settings, Accept Mode, Send Character

	7: Line and Tunnel Settings
Tunnel Packing Mode	Description
Settings (continued)
Send Character	Enter Control Characters in any of the following forms:
	 <control>J
	 0xA (hexadecimal)
	 \10 (decimal)
	If used, the Send Character is a single printable character or a control
	character that, when read on the Serial Line, forces the queued data to be
	sent on the network immediately.
Trailing Character	Enter Control Characters in any of the following forms:
	 <control>J
	 0xA (hexadecimal)
	 \10 (decimal).
	If used, the Trailing Character is a single printable character or a control
	character that is injected into the outgoing data stream right after the Send
	Character. Disable the Trailing Character by blanking the field (setting it to
	<None>).

To Configure Tunnel Packing Mode Settings

Using Web Manager

To configure the Packing Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Packing Mode.

Using the CLI

To enter the Tunnel 1 Packing command level: enable -> tunnel 1 -> packing

Using XML

Include in your file: <configgroup name="tunnel packing" instance="1">

Accept Mode

In Accept Mode, the PremierWave XN listens (waits) for incoming connections from the network. A remote node on the network initiates the connection.

The configurable local port is the port the remote device connects to for this connection. There is no report port or address. Supported serial lines and associated local port numbers progress sequentially in matching value. For instance, the default local port is 10001 for serial line 1 and the default local port for serial line 2 is 10002, and so on for the number of serial lines supported.

Serial data can still be received while waiting for a network connection, keeping in mind serial data buffer limitations.

PremierWave XN User Guide 50