Lantronix XN manual To Configure Host Settings, SSH Username, Remote Address, Remote Port

Page 59

 

 

8: Terminal and Host Settings

 

 

 

 

 

Host Settings (continued)

Description

 

 

SSH Username

Enter a username to select a pre-configured Username/Password/

 

 

 

Key (configured on the SSH: Client Users), or leave it blank to be

 

 

 

prompted for a username and password at connect time.

 

 

 

Note: This field appears if you selected SSH as the protocol.

 

 

Remote Address

Enter an IP address for the host to which the device will connect.

 

 

Remote Port

Enter the port on the host to which the device will connect.

 

 

 

 

 

To Configure Host Settings

Note: The following section describes the steps to view and configure Host 1 settings; these steps apply to other host instances of the device.

Using Web Manager

To configure a particular Host, click Host on the menu and select Host 1 -> Configuration.

Using the CLI

To enter the Host command level: enable -> config -> host 1

Using XML

Include in your file: <configgroup name=”host” instance=”1”>

PremierWave XN User Guide

59

Image 59
Contents XN User Guide Disclaimer WarrantyCopyright & Trademark ContactsUsing DeviceInstaller Table of ContentsUsing This Guide Installation of PremierWave XNLine and Tunnel Settings Configuration Using Web ManagerNetwork Settings Security Settings Terminal and Host SettingsServices Settings Maintenance and Diagnostics Settings Security in Detail Advanced SettingsBridging 103 VIP SettingsUpdating Firmware Branding the PremierWave XNPremierWave XN Product Label List of FiguresList of Tables PremierWave XN User Guide Chapter Description Using This GuidePurpose and Audience Summary of ChaptersDocument Description Additional DocumentationProtocol Support Key FeaturesIntroduction ApplicationsHardware Address Troubleshooting CapabilitiesConfiguration Methods Addresses and Port NumbersPort Numbers Product Information LabelIP Address Hardware Components Installation of PremierWave XNPackage Contents User-Supplied ItemsButton pin hole Signal Strength LEDsSerial PowerLeft LED Right LEDWPS Status Indicator Wlan Signal Strength Indicator at 5 GHzWlan Signal Strength Indicator at 2.4 GHz Back Panel 10 Diagnostic LED IndicationsFault Conditions Blink Pattern To Start WPS Wi-Fi Protected Setup WPSTo Show WPS Status Installing the PremierWave XNTo Cancel WPS Perform the following steps to install your device13 PremierWave XN Dimensions in Millimeters mm IP address was obtained dynamically Using DeviceInstallerAccessing PremierWave XN Using DeviceInstaller Device Detail SummaryCurrent Settings Description To access Web Manager, perform the following steps Configuration Using Web ManagerAccessing Web Manager Device Status Help Area Web Manager ComponentsWeb Manager Description See Navigating Web ManagerSyslog Protocol StackQuery Port SmartRoamNetwork Interface Description Settings Network SettingsNetwork Interface Settings Network Interface SettingsTo Configure Network Interface Settings To View Network Interface Status Network Link SettingsNetwork 1 eth0 Link Settings Network 1 Ethernet eth0 Description Link SettingsNetwork 2 Wlan wlan0 Description Link Settings Network 2 wlan0 Link SettingsNetwork 2 Link Scan Results on WebManager To Configure Network Link SettingsWlan Link Status and Scan Commands Network 2 Link ScanWlan Link Status Description To View Wlan Link Scan and Status InformationNetwork 2 Link Status Creating, Deleting or Enabling Wlan Profiles To Configure Wlan ProfilesWlan Profile Basic Settings Description Wlan ProfilesWlan Profile Basic Settings To Configure Wlan Profile Basic SettingsWlan Profile Advanced Settings Description To Configure Wlan Profile Advanced SettingsWlan Profile Advanced Settings Wlan Profile Description Security Settings Wlan Profile Security SettingsTo Configure Wlan Profile Security Settings 10 Wlan Profile Security SettingsWlan Profile WEP Settings Description Wlan Profile WEP SettingsTo Configure Wlan Profile WEP Settings 11 Additional WEP Settings for Wlan ProfileKey Wlan Profile WPA and WPA2/IEEE802.11i Settings12 Wlan Profile WPA and WPA2/IEEE802.11i Settings Wlan Profile WPA Description WPA2 SettingsTo Configure Wlan Profile WPA and WPA/IEEE802.11i Settings 13 Wlan Quick Connect To Configure Wlan Quick ConnectWlan Quick Connect Description Settings Wlan Quick ConnectLine Settings Description Line and Tunnel SettingsLine Settings Line Configuration SettingsLine Command Description Mode Settings To Configure Line SettingsLine Command Mode Settings Line Settings to modify these settings Tunnel SettingsSerial Settings Tunnel Serial Description Settings Line SettingsTunnel Serial Description Settings To Configure Tunnel Serial SettingsPacking Mode Tunnel Packing Mode SettingsTrailing Character To Configure Tunnel Packing Mode SettingsAccept Mode Send CharacterTunnel Accept Mode Description Settings Tunnel Accept Mode SettingsEmail on Connect To Configure Tunnel Accept Mode SettingsConnect Mode Block NetworkFlush Serial Data Tunnel Connect Mode SettingsTunnel Connect Mode Description Settings Reconnect TimerTunnel Disconnect Description Mode Settings To Configure Tunnel Connect Mode SettingsDisconnect Mode Tunnel Disconnect Mode SettingsModem Emulation To Configure Tunnel Disconnect Mode SettingsTunnel Modem Emulation Settings Tunnel Modem Description Emulation SettingsConnect String To Configure Tunnel Modem Emulation SettingsStatistics To View Tunnel StatisticsTerminal on Network and Line Settings Terminal and Host SettingsTerminal Settings Host Configuration Host ConfigurationTo Configure the Terminal Network Connection To Configure the Terminal Line ConnectionRemote Port To Configure Host SettingsSSH Username Remote AddressDNS Settings Services SettingsDNS Settings To View or Configure DNS SettingsFTP Settings FTP SettingsSyslog Settings To Configure FTP SettingsHttp Settings Description Http SettingsTo View or Configure Syslog Settings Http SettingsTo Configure Http Settings RSS Settings RSS SettingsTo Configure Http Authentication Http Authentication SettingsTo Configure RSS Settings SSH Server Host Keys Security SettingsSSH Settings RSS Settings DescriptionSSH Client Known Hosts SSH Client Known HostsSSH Server Authorized Users SSH Client Users Remote CommandSSH Client Users SSH Server Authorized UsersTo Configure SSH Settings SSL SettingsTo Create a New Credential Certificate and Key Generation SettingsCertificate Generation Description Settings Certificate and Key GenerationUpload Description Certificate Settings Certificate Upload SettingsTo Configure an Existing SSL Credential Upload Certificate SettingsTo Upload an Authority Certificate Trusted Authority SettingsTrusted Authorities File Display Maintenance and Diagnostics SettingsFilesystem Settings File Display SettingsFile Transfer File Modification SettingsFile Transfer Settings File ModificationIP Network Stack Settings Protocol Stack SettingsIP Settings To Configure IP Network Stack SettingsTo Configure ARP Network Stack Settings Icmp SettingsTo Configure Icmp Network Stack Settings ARP SettingsQuery Port Settings Smtp SettingsTo Configure Smtp Network Stack Settings To Configure Query Port SettingsTo View the List of IP Sockets DiagnosticsHardware To View Hardware Information IP SocketsTraceroute Ping Settings10 Traceroute Settings To Ping a Remote HostMemory To Configure the Diagnostic Log Output11 Log Settings LogTo View Thread Information ThreadsProcesses To View Process InformationSystem Settings Description System SettingsTo Reboot or Restore Factory Defaults 12 System SettingsEmail Configuration Advanced SettingsEmail Settings To View, Configure and Send EmailCLI Configuration Settings Command Line Interface SettingsBasic CLI Settings To View and Configure Basic CLI SettingsSSH Settings To Configure Telnet SettingsSSH Settings Telnet SettingsXML Export Configuration Description Settings XML SettingsXML Export Configuration XML Exporting ConfigurationTo Export in XML Format To Export Configuration in XML FormatXML Export Status Description Settings XML Export StatusTo Import Configuration in XML Format XML Import ConfigurationImport Configuration from External File Import Configuration from the FilesystemBridging Bridging ConfigurationTo configure and enable bridging Wlan Profile WPA & WPA2 Description Settings Bridge ConfigurationTo View or Configure Bridge Settings Bridge Settings Include in your file configgroup name=bridge instance=br0 Trusted Authorities Security in DetailPublic Key Infrastructure Digital CertificatesOpenSSL Obtaining CertificatesSelf-Signed Certificates Certificate FormatsFree Radius Steel Belted RadiusObtaining Firmware Loading New Firmware through FTP Updating FirmwareVirtual IP VIP Status VIP SettingsVirtual IP VIP Configuration To Configure VIP SettingsVIP Counters Description Virtual IP VIP CountersTo View VIP Counters VIP CountersWeb Manager Customization Branding the PremierWave XNTo Customize Short or Long Names Short and Long Name SettingsShort and Long Name Customization Technical Support Europe, Middle East, Africa Appendix a Technical SupportTechnical Support US Scientific Calculator Appendix B Binary to Hexadecimal ConversionsConverting Binary to Hexadecimal Conversion TableAppendix B Binary to Hexadecimal Conversions Appendix C Compliance RoHS Notice Manufacturers Contact
Related manuals
Manual 1 pages 1.27 Kb