Vincent Audio SV-234 manuel dutilisation Safety Guidelines

Page 24

SAFETY GUIDELINES

This appliance was produced under strict quality controls.

It complies with all established international safety standards. Nonetheless, the following instructions should be fully read and observed in order to prevent any hazard:

Do not open the appliance! Risk of electric shock!

There are no parts in the appliance that require maintenance by the user.

Maintenance/Alterations

All equipment that is connected to the domestic mains voltage can be dangerous to the user if not handled properly. Leave maintenance work to qualified profes- sionals. The product is only permitted for connection to AC 230Volt/50Hz, for earthed sockets and use in enclosed areas. Altering the product or manipulating its serial number voids the warranty. After a fault, leave the appliance’s fuse to be replaced only by a professional with one of the same kind.

Power Cable Connection

Always pull the plug and never the power cable if you want to disconnect the appliance from the mains power. Make sure when setting up the appli- ance that the power cable is not squashed, severely bent or damaged by sharp edges. Do not touch the power lead with wet or damp hands. Use the power cable supplied or another one from Vincent.

 

ON

Switching Off

OFF

Switch the appliance off every time before you con- nect or remove other components or loudspeakers, disconnect or connect it to the mains power, leave it unused for a longer period or want to clean its outsi- de. On all amplifiers and receivers, wait approx. 1 minute after this before disconnecting or reconnecting the cable.

Moisture/Heat/Vibration

Contact of electrically operated equipment with liquids, moisture, rain or water vapour is dangerous for such equipment and the user and must be avoi-

ded without fail. Take care that no liquids or objects get inside the appliance (ventilation slots etc.).

It must be disconnected from the mains power imme- diately and examined by a professional if this hap- pens. Never expose the appliance to high tempera- tures (direct sunshine) or strong vibration.

Heat Build-up

All amplifiers generate heat as part of their design. Make sure that a gap of 5 cm remains around the appliance and that the surrounding air can circula- te (do not install in enclosed cupboards). Vents must not be covered up.

Volume

The maximum tolerable volume is always reached well below the maximum possible setting on the amplifier. Be careful with the volume setting, therefore, in order to prevent damage to hearing. So that you do not expose yourself to high volumes unintentionally, always set to a low level before changing the input channel.

Cleaning

Pull out the power plug before cleaning the outside of the product. Whenever possible, use a soft, lint- free cloth that has been dampened. Do not use abra- sives, solvents, thinners, flammable chemicals, polis- hes and other cleaning products that leave marks.

Batteries

Take note of the instructions for using batteries in the chapter "Remote Control".

24Vincent

Image 24
Contents Vincent Sehr geehrter Kunde Dear CustomerCher client INHALTSVERZEICHNIS/CONTENTS/SOMMAIRE Wartung/Veränderungen Alle Betriebsmittel, die an die NetzspannungNetzkabel/Anschluss Aus/AnschaltenErläuterung der grafischen Symbole Weitere HinweiseCE-Zeichen Erklärungen/HinweiseLieferumfang Beschreibung DES GerätesPower Netzschalter VorderansichtAnzeige LEVEL/ LautstärketastenPower Control RückansichtFernbedienung BatterienGain Taste für -8dB Abschwächung aller Ausgangssignale Tasten DER FernbedienungEingangswahltasten Hören möchtenInstallation ZUR Besonderen BeachtungAnschluss DER Quellgeräte MIT CINCH-HOCHPEGELAUSGANG Anschluss Eines Quellgerätes MIT STEREO-XLR-AUSGANGKabelverbindungen FÜR DIE Einschaltsteuerung Power Control SV-234 Endverstärker Anschluss Eines Aufnahmegerätes Anschluss Zweier Zusätzlicher EndstufenkanäleAnschluss DER Lautsprecher Anschluss DES Netzkabels Bedienung DES Gerätes Und die Lautstärkeschritte sind zu grob GainUnd REC Output 13 werden kleiner Helligkeit derWeitere Tipps Einspielzeit/AufwärmenNetzbrummen Symptom Mögliche Fehlerursache Abhilfe FehlersucheTechnische Daten LEXIKON/WISSENSWERTES Audio-Quellen/Audio-QuellgeräteSafety Guidelines Other Instructions Included in Delivery Description of the ApplianceFront View Rear View Speaker Loudspeaker terminalsIf desired, you can connect a recording device PRE Output Preamplifier OutputRemote Control Using batteriesBatteries Old NewButtons of the Remote Control Level and Level Volume keysMute Input Selector ButtonsDo not connect PRE OUT and Main Speaker cable connectionsProtective caps RCA connectionsConnection of ONE Audio Source with XLR Output Connections for the Standby Control Power Control SV-234 is intended to react to the trigger signal Connection of a Recording Device Connection of TWO Additional Main Amplifier ChannelsConnection of the Loudspeakers Connection of the Power Cable Operating the Appliance Signal output of the preamplifier PRE Output Corresponding remote controller buttons as well as usingPRE Output 14 is smaller Gain -08dB ← ... → Gain -00dBTips Burn in/ Warm upNet frequency noise Search for Errors Symptom Possible Cause CountermeasureTechnical Specifications Glossary Audio Sources/Source devicesConsignes DE Securite Entretien/ModificationsCâble dalimentation/Branchement Humidité/Chaleur/VibrationsExplication des symboles graphiques Autres ConsignesSigle CE Explications/RemarquesObjet DE LA Livraison Description DE LappareilLEVEL/ touches de volume Facade AvantAffichage Facade Arriere Speaker bornes de raccordementInput Balanced entrée XLR Telecommande PilesTouches DE LA Télécommande Level et Level touches de volumeQuand l’entrée Line 5 Main Input est sélec- 19 tionnée Pas de nécessité de liaison préampli, ampli de puissance Dépose du capot de protectionPrises RCA Fiches de raccordementsRaccordement D’UN Appareil Source Avec LA Sortie STEREO-XLR Amplificateur stéréo SV-234 Par ex. amplificateur Raccordement D’UN Appareil D’ENREGISTREMENT Branchement DES HAUT-PARLEURS Branchement DU Câble Dalimentation Commandes DE L‘APPAREIL Le volume a été augmenté Progressivité du réglage est trop grossière8dB amortissement De niveauConseils Temps de rodage / échauffementRonflement du secteur ’expérience montre que ce phénomène est soit dûResolution DE Problemes Symptôme Cause possible du défaut RemèdeCaracteristiques Techniques Lexique / BON a Savoir Sources audio/lecteurs sourcesVincent

SV-234 specifications

The Vincent Audio SV-234 is a high-end integrated amplifier that embodies a blend of modern technology and classic audio performance, appealing to both audiophiles and casual listeners alike. This sophisticated device is designed to provide pure, dynamic sound reproduction while integrating seamlessly with various audio sources and systems.

One of the key features of the SV-234 is its dual-mono design, which enhances soundstage and imaging. The separate amplifier sections for left and right channels ensure minimal crosstalk, leading to a more immersive listening experience. This design principle is essential for delivering a clean and accurate audio signal, effectively minimizing distortion and maximizing fidelity.

The amplifier boasts an impressive power output, rated at 2 x 150 watts into 8 ohms and 2 x 240 watts into 4 ohms. This significant power output allows the SV-234 to drive a wide range of speakers effortlessly, making it suitable for various configurations, from compact bookshelf speakers to larger floor-standing models. In addition to power, the unit's class AB amplification technology provides a warm and engaging sound that appeals to discerning listeners.

In terms of connectivity, the Vincent Audio SV-234 is equipped with an array of inputs, including multiple line-level analog inputs, a phono input for turntables, and digital inputs, including USB, coaxial, and optical. This extensive selection makes it easy for users to integrate the amplifier into their existing audio setup, allowing for playback from various sources, such as CD players, streaming devices, and computers.

The SV-234 is also designed with user-friendly features, such as a remote control and a clear, intuitive front panel layout. The built-in digital-to-analog converter (DAC) enhances sound quality when using digital sources, ensuring that users receive the best possible listening experience regardless of the input method.

In terms of build quality, the SV-234 features a sturdy, elegant chassis that is both aesthetically pleasing and robust enough to withstand everyday use. The combination of high-quality components and innovative technologies makes this amplifier a testament to Vincent Audio's commitment to creating exceptional audio products.

Ultimately, the Vincent Audio SV-234 is a remarkable integrated amplifier that combines power, versatility, and exceptional sound quality. Its advanced features and thoughtful design make it an ideal choice for anyone seeking to elevate their audio experience.