Falcon SG5K-2TX, SG6K-2TC Care & Maintenance, Battery Life vs. Temperature, Battery Replacement

Page 26

CHAPTER 5

Maintenance & Technical Support

1.Care & Maintenance

FALCON® SG Series UPSs are designed to be maintenance-free. They can be cleaned with a damp cloth or non-abrasive cleanser, providing the UPS is turned off and the input plug is disconnected from the utility source.

On a regular basis, check the vents to make sure they are kept free from accumulation of dust, dirt or lint.

2.Battery Life vs. Temperature

For full battery life, keep the UPS close to an ambient temperature of 77ºF. The batteries should never be exposed to temperatures below 40ºF and above 104ºF.

.

3.Battery Replacement

This UPS contains sealed maintenance-free batteries (VRLA). When situated in a typical office environment, with the proper charging and limited cycling, the batteries can last many years. In home, office or computer room environments, the batteries should be replaced every three to five years.

Battery Replacement Must Be Performed by Qualified Personnel.

WARNING

Never attempt to service batteries. High voltage exists within the unit, which could cause electrical shock. Servicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required precautions. Keep unauthorized personnel away from batteries.

When replacing the UPS batteries, use the same number and type of batteries.

NEVER

A. NEVER dispose of batteries in a fire, as batteries will explode.

B. NEVER dispose of used batteries or the UPS in the trash or landfill as it is against federal and state laws. The UPS and Batteries must be recycled. For UPS and battery recycling information, please contact our service department for the name and address of the nearest battery recycling facility.

CAUTION

A. Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes. It may be toxic.

B. A battery can present a risk of electrical shock and has a high short circuit current.

REFER ALL BATTERY SERVICING OR REPLACEMENT TO A

QUALIFIED SERVICE TECHNICIAN. NEVER ATTEMPT TO

REPLACE THE BATTERIES YOURSELF.

24

Image 26
Contents Owners Operating Manual Table of Contents SG Series ON-LINE UPS System Block Diagram Important Safety Instructions Electric, IncTrue Regenerative On-Line Design Input Power Factor CorrectionExtended Battery Bank Option Microprocessor ControlInstallation Instructions General Common for all modelsDisregard On Designation Leveling Feet Adjustment Model Output Requirements View of the Input/Output Hardwire Terminal BlockUPS Output Requirements Do not USE the Upper Terminal ConnectionsInternal UPS Diagram SG5K-2TC & SG6K-2TCInstallation Instructions SG5K-2TXC & SG6K-2TXCExtended Battery Bank Selection Guide USE Copper Conductors only UPS Output Details Model RequiredReceptacle Output Power Distribution Center Typical Power Distribution Center ConfigurationRefer to page 20 for Operating Instructions Installation Procedure Extended Battery Bank DC InterconnectionAll models except hardwire Line / Site Wiring Fault Indicator LED Load Level Indicator LEDsBattery Level Indicator LEDs Battery Mode Indicator LEDGreen Mode LED Indicator Bypass Indicator LEDInverter Indicator LED Over Crest Indicator LEDCategory two alarms Audible AlarmsCategory one alarms Page Supported Protocols Communications InterfacesLocation DRY Contact & Opto Coupler Interface Board Options PIN Assignment for the Falcon Battery Replacement Care & MaintenanceBattery Life vs. Temperature Storing the UPS and Batteries FCC ConsiderationsSUPPORT@FALCONUPS.COM Technical SupportRequesting Technical Information or Support 800.842.6940 Falcon Web SupportWarranty General Provisions6kVA Models