Falcon SG6K-2TC, SG5K-1TXC, SG5K-2TXC, SG5K-2TC Storing the UPS and Batteries, FCC Considerations

Page 27

The following precautions should be observed by a qualified technician when working with batteries.

1.Remove watches, rings, or other metal objects.

2.Use tools with insulated handles.

3.Wear rubber gloves and boots.

4.Do not lay tools or metal parts on top of batteries.

4.Storing the UPS and Batteries

Should you need to store the UPS for a long period, fully recharge the battery just prior to storage and recharge the battery every 4 months by plugging the UPS into a power outlet. It is recommended that the batteries charge for 24 hours after long-term storage.

5.FCC Considerations

This equipment generates and uses radio frequency energy and if not installed and used properly in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. All models covered in this manual have been tested and found to comply with the limits for a Class A computing device, in accordance with the specifications in FCC regulations, Part 15, Subpart J, which are designed to provide reasonable protection against such interference.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

a. Reorient or relocate the receiving antenna.

b. Increase the separation between the equipment and the receiver.

c. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

d. Consult the dealer or an experienced radio/television technician for assistance.

25

Image 27
Contents Owners Operating Manual Table of Contents SG Series ON-LINE UPS System Block Diagram Electric, Inc Important Safety InstructionsMicroprocessor Control Input Power Factor CorrectionExtended Battery Bank Option True Regenerative On-Line DesignGeneral Common for all models Installation InstructionsDisregard On Designation Leveling Feet Adjustment Model Do not USE the Upper Terminal Connections View of the Input/Output Hardwire Terminal BlockUPS Output Requirements Output RequirementsSG5K-2TC & SG6K-2TC Internal UPS DiagramSG5K-2TXC & SG6K-2TXC Installation InstructionsExtended Battery Bank Selection Guide USE Copper Conductors only Model Required ReceptacleUPS Output Details Typical Power Distribution Center Configuration Output Power Distribution CenterRefer to page 20 for Operating Instructions Extended Battery Bank DC Interconnection All models except hardwireInstallation Procedure Battery Mode Indicator LED Load Level Indicator LEDsBattery Level Indicator LEDs Line / Site Wiring Fault Indicator LEDOver Crest Indicator LED Bypass Indicator LEDInverter Indicator LED Green Mode LED IndicatorAudible Alarms Category one alarmsCategory two alarms Page Communications Interfaces LocationSupported Protocols DRY Contact & Opto Coupler Interface Board Options PIN Assignment for the Falcon Care & Maintenance Battery Life vs. TemperatureBattery Replacement FCC Considerations Storing the UPS and Batteries800.842.6940 Falcon Web Support Technical SupportRequesting Technical Information or Support SUPPORT@FALCONUPS.COMGeneral Provisions Warranty6kVA Models