Enterasys Networks 9034310-01, 2G4082-25 manual Overview of DFE-Platinum Module Shutdown Procedure

Overview of DFE-Platinum Module Shutdown Procedure

Table 4-2 Troubleshooting Checklist (continued)

Problem Possible Cause Recommended Action

User parameters	Position of Mode switch (7),
(IP address, device	Persistent Data Reset, was
and module name,	changed sometime before
etc.) were lost	either cycling power or
when the module	pressing the OFFLINE/
power was cycled,	RESET switch, causing the
the front panel	user-entered parameters to
OFFLINE/RESET	reset to factory default
switch was	settings.
pressed.	Clear Persistent Data that
	was set through Local
	Management.
	The module was moved
	either from slot-to-slot or
	from chassis-to-chassis.

Reenter the lost parameters as necessary. Refer to the Enterasys Matrix DFE-Diamond/Platinum Series Configuration Guide for the instructions to configure the device.

If the problem continues, contact Enterasys Networks for technical support.

Overview of DFE-Platinum Module Shutdown Procedure

Caution: Do not remove a DFE module from an operating chassis system before reading the following information and instructions.

Precaución: Antes de retirar los módulos DFE del chasis en funcionamiento, lea las siguientes instrucciones y la información suministrada.

The DFE‐Platinum module must shut down in an orderly fashion to ensure that the other modules in the system and other devices on the network are notified of the impending change. The devices can then make intelligent decisions and stabilize the network before the change is made; thereby increasing network availability.

You can shut down a DFE‐Platinum module in an operating system using the OFFLINE/RESET switch shown in Figure 4‐2. There are two procedures to shut down a DFE‐Platinum module.

•“Recommended Shutdown Procedure” (page 4‐6)

•“Last Resort Shutdown Procedure” (page 4‐6)

Figure 4-2 OFFLINE/RESET Switch

Gb ENET

2G4082-25

1

11X

OFFLINE/	À
RESET
COM

MGMT CPU

GROUP

SELECT

GROUP

1 1

2 2

3

4

5

6

7

8

9 10

12X

11

12

1OFFLINE/RESET switch

Matrix DFE-Platinum Series Installation Guide 4-5