Enterasys Networks 9034310-01, 2G4082-25 manual Alternating 67% on, 33% off

Using LANVIEW

Table 4-1 LANVIEW LEDs (continued)

LED

Color

State

Recommended Action

CPU

None

Power off.

Ensure chassis has adequate power.

Amber

Blinking. Module in process of

None.

booting.

Solid. Testing.

If the LED remains amber for several

minutes, contact Enterasys Networks for

technical support.

Green

Blinking. Image starts running.

None.

Solid. Functional.

None.

Red

Solid. Processor in reset.

None.

Green

Blinking. Indicates that the

None. This state is activated when the

and

module is in the process of

OFFLINE/RESET switch is pressed for less

Amber

shutting down.

than 1 second to a start the process of an

orderly shutdown.

While in this state, do not remove any

DFE-Platinum module.

Amber

Alternating (67% on, 33% off).

While in this state, you have 60 seconds to

and off

Indicates that a shutdown

safely remove the DFE-Platinum module

process has completed. This

from the chassis.

indication will remain for 60

seconds before automatically

restarting.

RX

None

No link. No activity. Port

None.

(Receive)

enabled or disabled.

Green

Solid. Link present, port

None.

enabled, no traffic is being

received by the interface.

Amber

Flashing. Link present, port

None.

enabled, traffic is being received

by the interface.

TX

None

Port enabled, but no activity.

If it is known that the port should be active

(Transmit)

and is not, contact Enterasys Networks for

technical support.

Green

Flashing. Indicates data

None.

transmission activity. Rate of

flashing indicates the data rate.

Red

Flashing. Fault or Error

None, unless there is a high rate of activity.

(collision).

In this case, check for network configuration

problems or a defective device.