RAD Data comm RIC-E1 Mbps full duplex, 285 ∝s, Throughput, Data 00, 01, 02, …, 802.1p

Appendix C IR-ETH/V Interface ModuleRIC-E1Installation and Operation Manual

C.3 Technical Specifications

Bridge	LAN Table	2,048 MAC addresses
	Aging	5 minute, automatic
	Latency	10 Mbps full duplex, 360 ∝s
	(Frame size 64 bytes)	100 Mbps full duplex, 285 ∝s
	Throughput	4050 pps with 64 byte frame length and increment byte
		data (00, 01, 02, …)
	Buffer Size	120 frames (Frame size 64 bytes)
LAN	Standard	IEEE 802.3/Ethernet V.2, IEEE 802.1q (relevant parts),
		802.1p, 802.3x
	Data Rate	10BaseT: 10 Mbps
		100BaseT: 100 Mbps
	Transmission Line	4-wire, Category 5 UTP, 19 AWG to 26 AWG
	Line Code	10BaseT: Manchester
		100BaseT: MLT3
	Packet length	Up to 1536 bytes
	Connector	RJ-45 (Automatic MDIX support)
WAN	Protocol	Point-to-point
	Data Rate	Up to 2048 kbps
	Priority Queues	2

C.4 Installation and Operation

Figure C-4shows the DIP switch locations and the default settings of the

IR-ETH/V PCB.

Note The screen print tables on the IR-ETH/V PCB are look-up tables of the function enabled settings. The tables do not show the default settings.

For example, MDI in OFF position, MDI is enabled.

SW2

ON

1. 100 2. AN 3. FDX 4. NC 5. NC 6. NC

SW1

ON

1. MDI 2. NC 3. NC 4. FLC 5. FIL 6. FP 7. NC 8. NC

Figure C-4. SW1 and SW2 DIP Switch Locations

C-4 Installation and Operation

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com