RAD Data comm RIC-E1 View Menu, Configuration and Connection, To access the View menu

Appendix D IR-IP Interface Module		RIC-E1Installation and Operation Manual
Note	This operation restarts the IR-IP LAN controller.
	To continue your Telnet session, press any key within 15 seconds following the
	confirmation of the reset operation.
	Resetting the WAN Interface
	To reset the WAN interface:
	• From the Resets menu, type 3.
	You will be prompted to confirm the reset operation.
Note Resetting the WAN interface causes the WAN controller to be restarted. This results
	in renegotiation of the WAN protocol parameters.
	To continue your Telnet session, press any key within 15 seconds following the
	confirmation of the reset operation.

D.11 View Menu

The View menu is used to view the IR-IP configuration data, and display information on its ARP tables, multicast Groups tables and statistics.

To access the View menu:

• From the Main menu, type 5.

The View menu appears (Figure D-22).

IR_IP <IR-IP> S/W Ver. 1.21 31/IR (date)

Quick Setup Management Access Advanced Setup Device Control View

----------------------------------------------------------

1.Configuration and Connection

2.ARP Tables

3.Multicast Groups Table

4.Statistics

Press one of the numbers to select or ESC:

Figure D-22. View Menu

Configuration and Connection

This screen is used to view the configuration parameters of IR-IP. In addition, you can also view the current status of the LAN and WAN interface.

To access the Configuration and Connection screen:

•From the View menu, type 1.

The View Configuration screen appears (Figure D-23).

D-26 View Menu

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com