Setup 5: Bundle the cords and cables
1Remove the arm cover.
2Bundle the cords and cables inside of the stand.
3Secure the cables and cords with the cable holder.
4Replace the arm cover and back cover.
1
arm cover
Hold at this point.
Setup 6:Turn on the monitor and computer
1Press the MAIN POWER switch on the left side of the monitor in the direction of [.
The 1 (power) indicator lights up in red.
MAIN POWER
lights in red
2
4
3
Note
back cover
2Press the 1 (power) switch on the front right of the monitor.
The 1 (power) indicator lights up in green.
US
lights in green
3 | Turn on the computer. |
4 | Press the INPUT button repeatedly and select the |
If you cannot bundle all of the cords and cables inside the stand, leave them hanging down outside the stand.
desired input signal. |
The selected input signal indicator lights up and the picture |
appears on the screen. |
For more information, see “Selecting the input signal (INPUT |
button)” on page 11. |
The installation of your monitor is complete. If necessary, use the monitor’s controls to adjust the picture (page 12).
(continued)
9