Cisco Systems 11.0 BT manual January 15

Page 1

Doc. No. 78-3610-09

Cisco IOS Release 11.0 BT Release Note and Update to Conﬁguration Guides and Command References

January 15, 1999

This document supplements the Cisco IOS Release 11.0 documentation set with new and changed commands that support Cisco IOS Release 11.0(10)BT and later. Note that Cisco IOS Release 11.0(10)BT is the initial release of Cisco IOS Release 11.0 BT. No prior versions of Cisco IOS Release 11.0 BT exist. The TN3270 server function is supported on a Channel Interface Processor card in a Cisco 7000 series or Cisco 7500 series router. The following Cisco IOS releases are covered by this release note publication:

•

•

•

•

Cisco IOS 11.0(10)BT

Cisco IOS 11.0(11)BT

Cisco IOS 11.0(12)BT

Cisco IOS 11.0(13a)BT

Note Cisco IOS Release 11.0(13)BT was renumbered and released as 11.0(13a)BT.)

•Cisco IOS 11.0(14)BT, Cisco IOS 11.0(14a)BT1

Note Shipment of Cisco IOS Release 11.0(14)BT was halted due to CSCdj05366. A ﬁx was implemented and the release was renumbered and released as 11.0(14a)BT1.

Corporate Headquarters

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

Copyright © 1998
Cisco Systems, Inc.	1
All rights reserved.	1

Image 1

Contents January 15 Release Note IntroductionIntroduction CIP Boot Image Requirements Boot ROM RequirementsPlatform Support Cisco IOS PackagingMicrocode Software New Software Features in 11.010BT Update to Conﬁguration GuideConﬁguring TN3270 Server on the Channel Interface Processor Conﬁguring TN3270 on a Channel Interface Processor Configuring TN3270 on a Channel Interface ProcessorDynamic LU Allocation Formation of LU Model Type and NumberExamples of Model String Mapping Speciﬁc LU AllocationString from client Ascii Requested? String to Host Ebcdic Multiple Hosts Support SNA Session Switch-End Node DlurDirect PU Conﬁguration in Router Adapte Comman Name IP-address Type NumberIDBLK=05D Task Command TN3270 Configuration ModesTN3270 Conﬁguration Modes Dlur Conﬁguration Mode TN3270 Server Conﬁguration ModePU Conﬁguration Mode Dlur SAP Conﬁguration ModeCommands Allowed in Multiple Modes TN3270 Conﬁguration Task List TN3270 Configuration Task ListTask List for Multiple Appn Hosts Task List for Non-APPN HostsConﬁgure PU Parameters on the TN3270 Server Conﬁgure TN3270 ServerConﬁgure Dlur TN3270 Configuration Task List CommandConﬁgure SAPs under Dlur Monitor the TN3270 Server Conﬁgure PUs under DlurPu pu-name idblk-idnum ip-address Conﬁguration dialog to conﬁgure the TN3270 function follows TN3270 Conﬁguration ExampleSYD.TN3020 SYD.VMG Update to Command Reference Update to Command ReferenceDlur DlurDlus-backup Dlus-backupGeneric-pool Generic-poolFollowing command permits generic LU pool use Idle-time Idle-timeKeepalive KeepaliveLink LinkLsap token-adapter Link Host rmac 4000.0000.0001 rsap Lsap LsapInternal adapter type on the CIP card, which corresponds to 4. It must be unique within the internal adapter in that noRelated Commands Maximum-lus Maximum-lusPreferred-nnserver Preferred-nnserverPu direct Pu directHosts are in which domains and does not enforce the unique PUs may use the same value on the internal adapter as longWhen a speciﬁc LU name request is needed. The format can Defaults34 TN3270 Server Commands Pu Dlur Pu DlurThis value must match the idblk-idnum value deﬁned at Show extended channel tn3270-server Show extended channel tn3270-serverShow tn3270-server Field Descriptions LU numberNumber Fail numberDlur fq-cpname Dlus fq-dlusname38 TN3270 Server Commands Show extended channel tn3270-server client-ip-address Show extended channel tn3270-server client-ip-addressLU locaddr Show tn3270-server client-ip-address Field DescriptionsLU lu-name Ip-addrtcpport State lu-stateNumber/number Show extended channel tn3270-server dlur Show extended channel tn3270-server dlurShow tn3270-server dlur Field Descriptions VRN fq-name Show extended channel tn3270-server dlurlink Show extended channel tn3270-server dlurlinkShow tn3270-server dlurlink Field Descriptions TGN tg-numberShow extended channel tn3270-server pu Show extended channel tn3270-server puState pu-state Show tn3270-server pu Field DescriptionsLU states and their meanings are Show extended channel tn3270-server pu lu Show extended channel tn3270-server pu luShow tn3270-server pu lu Field Descriptions 50 TN3270 Server Commands Shutdown ShutdownTcp-port Tcp-portTiming-mark Timing-markTn3270-server Tn3270-serverUnbind-action Unbind-actionVrn VrnCisco Connection Documentation Cisco Connection OnlineCisco Connection Online Cisco Connection Documentation