dlur
dlur
Use the dlur TN3270 configuration command to enable the Systems Network Architecture (SNA) session switch function on the CIP, or to enter dependent logical unit requester (DLUR) configuration mode. Use the no form of this command to disable the SNA session switch function and discard all parameter values associated with the SNA session switch.
dlur
dlur
Syntax Description |
|
Fully qualified control point (CP) name used by the SNA | |
| session switch and the logical unit (LU) name for the |
| DLUR function. This name must be unique among APPN |
| nodes in the network including other |
| specified on all other TN3270 servers running under the |
| Cisco IOS software. |
Fully qualified name of the primary choice for the | |
| dependent LU server (DLUS). This is the name of an LU, |
| usually a CP, in an APPN host. The |
| be repeated and shared across servers. |
Default |
|
No DLUR function is enabled. |
|
Command Mode |
|
TN3270 configuration |
|
Usage Guidelines
If the SNA session switch function is already enabled, the dlur command with no arguments puts you in DLUR configuration mode.
Several parameters in the DLUR configuration mode consist of fully qualified names, as defined by the APPN architecture. Fully qualified names consist of two
The no dlur command hierarchically deletes all resources defined beneath it.
Example
The following command performs two functions: It enters DLUR configuration mode; and it enables the DLUR function and defines the LU name for the DLUR as SYD.TN3020 and the primary choice for DLUS as SYD.VMG. Note that the NETID portion of both names is the same:
dlur SYD.TN3020 SYD.VMG
20TN3270 Server Commands