Release Note
Platform Support
Cisco IOS Release 11.0 BT supports the following router platforms:
•
•
Cisco 7500 series
Cisco 7000 series and Cisco 7000 series with RSP7000
Cisco IOS Packaging
The following feature sets are available in Release 11.0 BT. Refer to the Router Products Release Notes for Cisco IOS Release 11.0 for a list of the features provided in the Cisco 7000 and Cisco 7500 series feature sets.
•
•
Enterprise (this feature set includes CIP)
Enterprise/CIP2
Boot ROM Requirements
Boot ROMs that support Cisco IOS Release 11.0 are required. No special requirements exist for
Cisco IOS Release 11.0 BT.
CIP Boot Image Requirements
The CIP boot image is bundled in the Cisco IOS Release 11.0 BT image. You must have the image that supports your CIP or your CIP2 hardware. You cannot run a CIP and a CIP2 card in the same router. See Table 1 for a list of image names and supported CIP or CIP2 cards.
Table 1 11.0 BT Image Names for CIP and CIP2 Hardware
Image Names | Supported CIP Hardware |
CIP | |
|
|
CIP2 | |
|
|
CIP | |
|
|
CIP2 | |
|
|
Memory Requirements
The memory requirements for Cisco IOS 11.0 BT are shown in Table 2. The CIP supports up to 128 Mb of memory.
Table 2 11.0 BT Memory Requirements
Cisco 7500 Series |
|
|
|
|
and Cisco 7000 | Minimum Required | Required Main | Required CIP | Release 11.0 |
with RSP7000 | Code Memory | Memory | Memory | Runs From |
|
|
|
|
|
Enterprise Set | 8 MB Flash memory | 24 Mb | 32 Mb | RAM |
card |
|
|
| |
|
|
|
|
|
Enterprise/CIP2 Set | 8 MB Flash memory | 24 Mb | 32 Mb | RAM |
card |
|
|
| |
|
|
|
|
|
Cisco IOS Release 11.0 BT Release Note and Update to Configuration Guides and Command References 3