Cisco Systems 11.0 BT manual Pu Dlur, This value must match the idblk-idnum value defined at

pu (DLUR)

pu (DLUR)

Use the pu DLUR configuration command to create a PU entity that has no direct link to a host or to enter PU configuration mode. Use the no form of this command to remove the PU entity.

pu pu-name

pu pu-name idblk-idnum ip-address no pu pu-name

Syntax Description
pu-name	Name that uniquely identifies this PU.
idblk-idnum	This value must match the idblk-idnumvalue defined at the
	host. The value must be unique within the domain;
	however, the TN3270 server generally cannot tell which
	remote hosts are in which domains, so the server only
	enforces uniqueness within the set of DLUR PUs.
ip-address	IP address that the clients should use as host IP address to
	map to LU sessions under this PU.
Default
No PU is defined.
Command Mode
DLUR configuration

Usage Guidelines

If the PU is already created, the pu pu-namecommand with no arguments puts you in PU configuration mode. In this mode you can modify an existing PU DLUR entity.

A typical usage for the IP address is to reserve an IP address per host application. For example, clients wanting to connect to TSO specify an IP address that will be defined with PUs that have

LOGAPPL=TSO.

Example

The following sequence of commands define three PUs. Two of the PUs share the same IP address and the third PU has a separate IP address:

pu p0 05D99001 192.195.80.40 pu p1 05D99002 192.195.80.40 pu p2 05D99003 192.195.80.41

TN3270 Server Commands 35