Bunn S/N SNG0033000 & UP manual Assign Recipes, Assign Recipe ?, Enable ADS?

PROGRAMMING THE BREWER (cont.)

ASSIGN RECIPES

This function allows for assigning a coffee name other than NO-NAMEto the BREW switch.

Procedure to assign recipes:

1.Press and hold the upper right hidden switch until the display reads UNITS. Release the switch, then press and release switch until the display reads

ASSIGN RECIPE ?.

2.Press YES to assign a recipe to the BREW switch.

3.Use (-)and (+) to select recipe which you want to assign to the BREW switch.

4.Press and release DONE when selected to advance to next function screen, ENABLE ADS.

Procedure to Enable/Disable Ads:

1.Press and hold the upper right hidden switch until the display reads UNITS. Release the switch, then press and release switch until the display reads ENABLE ADS. The YES or NO will be flashing to indicate the current selection.

2.Press and release the NO switch to disable this function (no ads will be displayed on the screen), or;

3.Press and release the YES switch to enable this function (ads will be displayed on screen).

4.When finished, press and release DONE to save the new setting, exit the ENABLE ADS function and advance to the next function screen, SET TEMP. Another alternative is to press the ON/OFF switch located on the front switch panel to exit the ENABLE ADS function and return to the MAIN SCREEN.

ASSIGN RECIPE ?

NOYES

SELECT RECIPE

5 SEC. DELAY

NO-NAME

(-) DONE (+)

EXIT TO

NEXT FUNCTION

SCREENP3515

ENABLE ADS?

This function allows the operator to choose whether or not to display the advertising message that was en- tered into the brewer with an AD CARD. This message will be displayed when the brewer is not in use.

ENABLE ADS ?

NO DONE YES

ο ο ο ο

SET TEMP - Range: 185˚F (85˚C) to 205˚F (96˚C)

This function allows the operator to set the brew water temperature in the tank. It also sets the hot water faucet dispense temperature.

P2721

Page 32 35879.1 071405