NCR S16 manual Configuration Settings Required for Installing MP-RAS, Shadow Options

Configuration Settings Required for Installing MP-RAS

Configuration Settings Required for Installing MP-RAS

The configuration settings required for MP-RAS are listed in this section.

Hard Disk Group

∙On-Board IDE Hard Disk Controller – Disabled

Parallel Port

∙Enabled - base address 3BCh

Serial Port Group

∙Port 1 – Enabled – address 03F8h

∙Port 2 – Enabled – address 02F8h

Shadow Options

∙E0000h - FFFFFh (System BIOS) – Enabled

∙C0000h - C7FFFh (Video BIOS) – Enabled

∙Memory at 15 MB-16 MB – Reserved for System Use

Cache

∙L1 and L2 Cache – Enabled

∙ECC/Parity Mode Selection – ECC

∙Operation of ECC Correction Enabled

Other Configuration Settings

∙Keyboard control – Enabled

∙On Board PS/2 Mouse (IRQ 12) – Enabled

∙Num Lock after boot – Enabled

NCR S16 Minitower Server Installing Network Operating System 11-15