NCR S16 manual SCO Release 5 Installing TCP/IP Communications, Inserting the SMC SuperDisk

SCO Release 5: Installing TCP/IP Communications

SCO Release 5: Installing TCP/IP

Communications

To install TCP/IP, follow these steps:

1.Enter Maintenance Mode (Press Enter on boot, init 1 or shutdown -i1).

2.Type “/etc/custom” and press Enter.

3.Select Software and then Install New.

4.At the “What host to install from?” prompt, press Enter.

Inserting the SMC SuperDisk

To insert the SMC SuperDisk, follow these steps:

1.When prompted to insert the media and select the media device, insert the

SMC SuperDisk for SCO UNIX into the flex drive. Verify the Media Device is set for Floppy Disk Drive 0. Press to get the choices for the media devices.

2.Observe the message, “Installing: SMC-SCO LLI 3.4 Super Disk (version 1.1.3a).”

3.At the “Do you want a FULL or PARTIAL installation?” prompt, select FULL.

4.Ignore all error messages.

5.After the SMC software drivers are installed, return to the UNIX prompt.

Completing the Installation

To complete the installation, follow these steps:

1.At the # prompt type “netconfig.”

2.Select Hardware and Add New LAN Adapter.

3.Select “smpw SMC 8432, 8434 and 9332 Ethernet Adapter, board 0.”

NCR S16 Minitower Server Installing Network Operating System 8-9