Back to Contents Page
Memory
Dell™ OptiPlex™ 320 User's Guide
DDR2 Memory Overview
Addressing Memory With
Removing Memory
Installing Memory
For information on the type of memory supported by your computer, see the "Memory" section of the specifications for your computer:
•Mini Tower Computer Specifications
•Desktop Computer Specifications
NOTICE: Before you install new memory modules, download the most recent BIOS for your computer from the Dell Support website at support.dell.com.
DDR2 Memory Overview
NOTICE: Do not install ECC memory modules. Doing so may cause the system not to boot or affect performance.
If the DDR2 memory modules are not installed with the same amount of memory in each channel, the computer will continue to operate, but with a slight reduction in performance. See the label in the corner of the module to determine the module's capacity.
NOTE: Always install DDR2 memory modules in the order indicated on the system board.
Be sure to install a single memory module in DIMM1, the connector closer to the processor, before you install a module in the other connector.
The recommended memory configurations are:
•A pair of matched memory modules installed in connectors DIMM1 and DIMM2
or
•A memory module installed in connector DIMM1
Addressing Memory With
This computer supports a maximum of 4 GB of memory when you use two
NOTE: If you use a
The following components require memory address space:
•System ROM
•APICs
•Integrated PCI devices, such as network connectors
•PCI cards
•Graphics cards
•PCI Express cards (if applicable)
At
•If the total installed computer memory is less than the usable space, all installed computer memory is only available for use by the operating system.
•If the total installed computer memory is equal to or greater than the usable address space, a portion of installed memory is not available for use by