1
2
3power cable
6.Ensure that the data cable is securely connected to the connector on the system board.
7.Check all connectors to ensure that they are properly cabled and firmly seated.
8.Replace the computer cover (see Replacing the Computer Cover).
9.If the drive you just installed is the primary drive, insert bootable media into your boot drive. See the documentation that came with the drive for instructions on installing any software required for drive operation.
10.Enter system setup and update the appropriate Primary Drive option (0 or 1). See Entering System Setup.
11.Exit system setup, and reboot the computer.
12.Partition and logically format your drive before you proceed to the next step.
See the documentation for your operating system for instructions.
13.Test the hard drive by running the Dell Diagnostics (see Dell Diagnostics).
14.If the drive you just installed is the primary drive, install your operating system on the hard drive.
Adding a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it.
NOTICE: If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.
1.Check the documentation for the drive to verify that it is configured for your computer.
2.Follow the procedures in Before You Begin.
3.Remove the plastic
4.Gently spread the sides of the drive bracket and slide the hard drive into the bracket until the drive clicks into place.