Networking | Page 6 of 8 |
Dynamic Addressing Server · DHCP
· BOOTP
Printing a Network Configuration Page
The Network Configuration page shows how the network interface card on your multifunction printer is configured. The default settings are suitable for most applications.
1.Press until >SETUP appears, and then press .
2.Press until >Admin Menu appears, and then press .
3.Press until >Admin Reports appears, and then press
4.Press until >Server Address appears, and then press .
The Network Configuration page prints out.
Setting Network Protocols
When you first install the multifunction printer, all supported network protocols are enabled when you power the multifunction printer on. If a network protocol is enabled, the multifunction printer may actively transmit on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate unnecessary traffic, you can disable unused protocols.
1.Press until >SETUP appears, and then press .
2.Press until >Admin Menu appears, and then press .
3.Press until >Wired Net or >Wireless Net appears, and then press
4.Press until >Protocol appears, and then press
5.Press to select the desired settings, and then press
Port9100
FTP
SNMP UDP
EWS
Configuring TCP/IP
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012