Controller Object Commands
/cx show serial
This command reports the serial number of the specified controller /cx.
Example:
//localhost> /c0 show serial
/c0 Serial Number = F12705A3240009
/cx show pcb
This command reports the PCB (Printed Circuit Board) version of the specified controller /cx.
Example:
//localhost> /c0 show pcb /c0 PCB Version = RevX
/cx show pchip
This command reports the PCHIP (PCI Interface Chip) version of the specified controller /cx.
Example:
//localhost> /c0 show pchip /c0 PCHIP Version = 1.x
/cx show achip
This command reports the ACHIP (ATA Interface Chip) version of the specified controller /cx.
Example:
//localhost> /c0 show achip /c0 ACHIP Version = 3.x
/cx show numdrives
This command reports the number of drives currently managed by the specified controller /cx. This report does not include (logically) removed or exported drives. Also note that physically removed disk(s) will not be detected unless I/O is performed against the disk. See “/cx/px show smart” on page 71 for a workaround.
Example:
//localhost> /c0 show numdrives /c0 Number of Drives = 5
www.3ware.com | 29 |