AMCC 9590SE-4ME manual Cx set carvesize=1024..2048, Cx set autorebuild=onoff

Controller Object Commands

volume. Each volume can then be treated as an individual disk with its own file system. The default carvesize is 2 TB.

This feature is useful for operating systems limited to 2TB file systems.

For example, using the 2 TB default carvesize, a 3 TB unit will be configured into one 2 TB volume and one 1 TB volume. A 5 TB unit will be configured into two 2 TB volumes and one 1 TB volume.

When auto-carve policy is set to off, all new units are created as a single large volume. If the operating system can only recognize up to 2 TBs, space over 2 TB will not be available.

Example:

//localhost> /c0 set autocarve=on

Setting Auto-Carving Policy on /c0 to on ... Done.

/cx set carvesize=[1024..2048]

This command is only for 9000 series controllers.

This command allows you to set the carve size in GB. This feature works together with autocarve. See “/cx set autocarve=onoff” above for details.

Example:

//localhost> /c0 set carvesize=2000

Setting Auto-Carving Size on /c0 to 2000 GB ... Done.

/cx set autorebuild=onoff

This command is only for 9550SX and 9590SE controllers.

This command turns the Auto-Rebuild policy on or off. By default, autorebuild is on.

If the policy is on the firmware will select drives to use for rebuilding a degraded unit using the following priority order.

1.Smallest usable spare.

2.Smallest usable unconfigured (available) drive.

3.Smallest usable failed drive.

Note: Failed drives can be drives that have mechanically failed, or they can be drives that have been disconnected from the controller long enough for the controller to classify them as failed.

Enabling Auto-Rebuild allows you to add a drive to the controller and have it be available for a rebuild as soon as you tell the controller to rescan, without

www.3ware.com 51