AMCC 9590SE-4ME manual Unit Object Commands, Cx/ux show

Unit Object Commands

Unit Object Commands

Unit Object commands provide information and perform actions related to a specific unit, such as /c0/u1 (unit 1 on controller 0). For example, you use logical disk object commands for such tasks as seeing the rebuild, verify, or initialize status of a unit, starting, stopping, and resuming rebuilds and verifies, and setting policies for the unit.

Syntax

/cx/ux show

/cx/ux show attribute [attribute ...] where attributes are: initializestatusname(9000 series)

qpolicy(9550SX and 9590SE only)rebuildstatus serial(9000 series)statusverifystatus storsave(9550SX and 9590SE only)volumes(9000 series) identify (9550SX and 9590SE only)

/cx/ux show all

/cx/ux start rebuild disk=<p:-p...> [ignoreECC]

/cx/ux start verify	(7000/8000 only)
/cx/ux pause rebuild
/cx/ux resume rebuild	(7000/8000 only)
/cx/ux stop verify
/cx/ux flush
/cx/ux del [noscan] [quiet]
/cx/ux set autoverify=onoff
/cx/ux set cache=onoff [quiet]	(9550SX and 9590SE only)
/cx/ux set identify=onoff
/cx/ux set ignoreECC=onoff	(9550SX and 9590SE only)
/cx/ux set qpolicy=onoff
/cx/ux set name=string	(9000 series)

/cx/ux set storsave=protectbalanceperform [quiet](9550SX and 9590SE only)

/cx/ux migrate type=RaidType [disk=p:-p] [group=3456] [stripe=Stripe] [noscan] [nocache] [autoverify] (9000 only)

/cx/ux remove [noscan] [quiet]

/cx/ux show

This command shows summary information about the specified unit /cx/ux. If the unit consists of sub-units as with the case of RAID-1, RAID-5, RAID-10, RAID-50, then each sub-unit is further presented. If the Auto-Carving policy was on at the time the unit was created and the unit is over the carve size, multiple volumes were created and are displayed at the end of the summary information.

www.3ware.com 53