AMCC 9590SE-4ME manual Enclosure Object Commands, Ex show

Enclosure Object Commands

Enclosure Object Commands

Enclosure object commands provide information and perform actions related to a specific enclosure, such as /e0 and its elements, such as /e0/slot0. Enclosure object elements include slot, fan, and temperature sensor elements.

These commands support the 9550SX and 9590SE controllers. If you purchased an enclosure directly from a third-party vendor, the appropriate EPCT (Enclosure Port Configuration Table) must have been downloaded to the controller in order to take advantage of these commands.

If you have a 3ware Sidecar Kit for use with a Power Mac G5, the required EPCT file is already installed.

Syntax

/ex show		(9550SX and 9590SE only)
/ex show	attribute [attribute ...] where attributes are:
controllersslotsfanstemp		(9550SX and 9590SE only)
/ex show	all
/ex/slotx show		(9550SX and 9590SE only)
/ex/slotx show identify		(9550SX and 9590SE only)
/ex/slotx set identify=onoff		(9550SX and 9590SE only)
/ex/fanx	show	(9550SX and 9590SE only)
/ex/tempx show		(9550SX and 9590SE only)

/ex show

This command shows summary information on the specified enclosure /ex. This report consists of four parts; the Enclosure summary listing the present elements, a Fan summary section listing of all present fans, a Temperature Sensor summary section listing of all present temperature sensors and a Slot summary section listing of slots and associated information for the specified enclosure.

Typical output looks like:

//localhost> /e0 show

Encl Controllers

-------------------------

e0	/c0
Fan	Status

----------------------

fan0 OK

www.3ware.com 79