AMCC 9590SE-4ME Cx/bbu show batinst, Cx/bbu show lasttest, Cx/bbu show volt, Cx/bbu show temp

Chapter 2. CLI Syntax Reference

/cx/bbu show batinst

This command shows the date when the current battery was installed.

/cx/bbu show lasttest

This command shows the date the battery capacity was last measured. If the battery capacity test has never been run, then 'xx-xxx-xxxx' will be displayed.

Note: The estimated BBU capacity hours displayed is based on the measurement taken during the last test. If you have not run the BBU test command for some time, this number can be misleading. For information about running a test, see “/cx/bbu test [quiet]” on page 77.

/cx/bbu show volt

This command shows the voltage status of the battery. The status can be OK, HIGH, LOW, TOO-HIGH, and TOO-LOW. The HIGH and LOW are in warning range. TOO-HIGH and TOO-LOW are out of the operating range and indicate that it is time to replace the battery. (Contact AMCC to obtain a replacement battery.)

/cx/bbu show temp

This command shows the temperature status of the battery. The status can be OK, HIGH, LOW, TOO-HIGH, and TOO-LOW. The HIGH and LOW are in warning range. TOO-HIGH and TOO-LOW are out of the operating range and indicate that it may be time to replace the battery. (Contact AMCC to obtain a replacement battery.)

/cx/bbu show cap

This command shows the battery capacity in hours.

A value of '0 hours' will be displayed if the battery capacity test has never been run.

Note: The estimated BBU capacity hours displayed is based on the measurement taken during the last test. If you have not run the BBU test command for some time, this number can be misleading. You can use the command /cx/bbu show lasttest to check the date of the last test. For information about running a test, see “/cx/bbu test [quiet]” on page 77.

76 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5