Chapter 2. CLI Syntax Reference
/cx/px show status
This command displays the status of the drive attached to the specified port. (Definitions of the drive statuses are available in the 3ware Serial ATA RAID Controller User Guide.)
Example:
//localhost> /c0/p5 show status /c0/p5 Status = OK
/cx/px show model
This command displays the model of the drive attached to the specified port.
Example:
//localhost> /c0/p5 show model /c0/p5 Model = WDC
/cx/px show serial
This command displays the serial number of the drive attached to the specified port.
Example:
//localhost> /c0/p5 show serial /c0/p5 Serial =
/cx/px show firmware
This command displays the firmware version of the drive attached to the specified port.
Example:
//localhost> /c0/p5 show firmware /c0/p5 Firmware Version = 65.13G65
/cx/px show identify
This command applies only to 9550SX and 9590SE model controllers that have chassis control hardware (enclosure services) attached.
This command shows whether the LED of the drive attached to the specified port is set to on or off. For details, see “/cx/px set identify=onoff” on page 73.
Example:
//localhost> /c0/p5 show identify /c0/p5 Identify Status = on
70 | 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5 |