AMCC 9590SE-4ME Cx del verify=slotid, Cx del selftest=slotid, Cx set rebuild=enabledisable1..5

Chapter 2. CLI Syntax Reference

/cx del verify=slot_id

This command removes the verify background task in slot slot_id.

Example:

//localhost> /c1 del verify=3

removes verify background task in slot 3.

Warning: If all time slots are removed, be sure to also disable the schedule.

Otherwise the applicable background task will never occur

/cx del selftest=slot_id

This command removes (or unregisters) the selftest background task in slot slot_id.

Example:

//localhost> /c1 del selftest=3

Will remove selftest background task in slot 3.

Warning: If all time slots are removed, be sure to also disable the schedule.

Otherwise the selftest background task will never occur.

/cx set rebuild=enabledisable1..5

This command enables or disables all rebuild background task slots on controller /cx and sets the priority of rebuild versus I/O operations. When enabled, rebuild tasks will only be run during the time slots scheduled for rebuilds. If a rebuild is taking place when the schedule is enabled, it will be paused until the next scheduled time.

The priority of rebuild versus I/O operations is specified with 1..5, where 1 is more resources and 5 the least. Setting the value to 1 gives maximum processing time to rebuilds rather than I/O. Setting the value to 5 gives maximum processing time to I/O rather than rebuilds.

Enabling and disabling rebuild schedules is only for 9000 models, however the rebuild rate (1..5) applies to all controllers.

7000- and 8000-series controllers have only one setting for Task Rate; it applies to both rebuild and verify rates. This rate is not persistent following a reboot for 7000- and 8000-series controllers.

48 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5