Graco 24B596, 24B591 System Setup, Main Screen, Pump on Setup, Timer Setup

Setup

8.If the PIN Code you entered is correct, the System Setup Screen, shown in FIG. 22 displays.

9.If the PIN Code you entered is incorrect, the digits flash. The Code must be re-entered by repeating steps 4 and 5.

NOTE:

•As soon as any arrow key is pressed, the numerals stop flashing.

•To leave any Setup Screen and return to normal operation, press RESET.

System Setup

Main Screen

FIG. 22

1.Use the UP/DOWN arrows to move the cursor up and down through the list of setup screens (FIG. 22).

2.Press ENTER to display the selected setup screen.

3.When all setup operations are complete, press RESET to return to normal operation.

PUMP ON Setup

Pump On is the length of time the pump runs before its cycle is terminated by either a timer, a specific number of cycles or a certain pressure threshold is attained.

FIG. 23

1.Use the UP/DOWN Arrow keys to move the cursor over PUMP ON.

2.Press ENTER to display the PUMP ON setup screen.

TIMER Setup

FIG. 24

NOTE: Time is displayed in HH:MM:SS.

1.Use the Arrow keys to move the cursor over the PUMP ON time box.

2.Press ENTER.

3.Use the UP/DOWN arrows to move up and down through the numbers 0-9 until the first number in the PUMP ON time is displayed in the field.

4.Use the RIGHT arrow to move the cursor to the next field.

5.Repeat steps 3 and 4 until the desired time is dis- played.

6.Use the Arrow keys to move the cursor over the ENDED BY pull-down list.

18 313855H