Graco 24B591, 24B596 Component Identification, Keypad, Display, and Icons, Run Mode Functions

Page 3

Component Identification

Keypad, Display, and Icons

F

D

B

FIG. 1

Component Identification

E

!

A

C

Run Mode Functions

Direction Arrows

AUp and Down Arrow Keys: Adjusts contrast.

BLeft and Right Arrow Keys: Adjusts brightness.

•Press the LEFT and RIGHT ARROW keys simultaneously to manually start a pump cycle.

Keypad Icons

NOTE: Keypad Icons are described on Icon’s page 4.

CENTER Key: Press and hold for 3 seconds. Allows access to setup.

DRESET Key: Press and hold for 3 seconds. Resets unit to normal Pump Off state. Also is used to reset an alarm condition.

EFUNTION LED: See page 4 for a description of these icons.

FDISPLAY

313855H

3

Image 3

Contents GLC Lubrication Controller Important Safety InstructionsElectric Shock Hazard Direction Arrows Run Mode FunctionsComponent Identification Keypad, Display, and IconsIcons Typical Installation InstallationGrounding Installing the Lubrication ControllerOptional I/O Wiring Diagrams System Configuration and WiringSystem Configurations Modes of Operation Sensor Wiring ConfigurationsDivider Valve System System ConfigurationDual Line System Injector System System Wiring Input Sensor WiringSource Switch 2 or 3 Wire Type 30VDC Pump on = Time Pump OFF = TimePump on = Cycle or Pressure Pump OFF = Time Dry Contact, shown. For other configuration, see or FIGPump on = Cycle or Pressure Pump OFF = Machine Count System Wiring Options System Wiring Options Alarm Out 30VDC100/240VAC Setup System Setup PIN Mode EnabledSee Electric Connection Warning, Main Screen System SetupPump on Setup Timer SetupCycle END Setup Pressure SetupPump OFF Setup Cycle Mode SelectionTo Set the Pump OFF Option If Time is selected If Count is selectedIf Both is selected Power Up can be programmed one of four ways Power UP SetupThird At Power Up, immediately go to Pump on normal on time Pulsed Pump Screen Pulsed SetupTo enable PIN Code Entry PIN SetupDisplay Setup Quick Cycle SetupDisplay Backlight Quick Cycle Screen Setup LOW Level Filtering SetupLow Level Filtering Screen Setup Screen Identification Run ModePrelube Power Up Pump On Ended with PressurePump On Ended with Time Pump On Ended with Cycle Switch Activation Pump Off Ended with TimePump Off Ended with Machine Counts Pump Off Ended with Machine Counts Max Time Entered Alarms ScreenModes of Operation TroubleshootingProgram Settings Description Problem SolutionIP69K Technical DataMounting Hole Layout DimensionsGraco Information Graco Standard Warranty