Panasonic WJ-MP204C manual English Version

Page 2

ENGLISH VERSION

Caution:

Before attempting to connect or operate this product, please read the label on the bottom.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

 

The lightning flash with arrowhead sym-

 

bol, within an equilateral triangle, is

 

intended to alert the user to the pres-

 

ence of uninsulated "dangerous voltage"

 

within the product's enclosure that may

SA 1965

be of sufficient magnitude to constitute a

risk of electric shock to persons.

 

The exclamation point within an equilat- eral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appli- ance.

SA 1966

For U.S.A

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to com- puter or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compli- ance could void the user’s authority to operate this equip- ment.

The serial number of this product may be found on the bot- tom of the unit.

You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid identification in the event of theft.

Model No.

Serial No.

WARNING:

To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.

2

Image 2
Contents Operating Instructions English Version Important Safety Instructions Contents Features PrefaceDo not attempt to disassemble the appliance PrecautionsDo not drop metallic parts through slots Handle the appliance with careFront View Rear View Mounting One WJ-MP204C with the WV-Q204/1 InstallationMounting in the Rack Mounting two WJ-MP204Cs with the WV-Q204/2Camera Site Connection & SettingBasic Connection PS Data Control SiteUnitMultiConnection PS Data Camera SiteVideo Multiplexer Connection PS Data ModeDigital Disk Recorder Connection PS Data WV-CU50Matrix Switcher Connection Camera Communication WJ-MP204CSetting the unit number DIP Switch SettingUnit Number Setting OFFCamera Communication Protocol Alarm/Remote Terminal SettingPS Data Camera IN/OUTInternal Setting RS-485 Data Port Connection PS DataBasic Connection Internal Diagram Line Half DuplexRS-485 Terminal Connection Camera Communication Daisy ConnectionButtons used in the setup Setup ProceduresPrior to setup WJ-MP204C Setup MENUX.XX Communication SystemSetup menus System setup PS Data Setup Menus for PS DataCommunication setup PS Data Communication Unit Address Baud RateAlarm CAM no PRE 1CH 2CH 3CH 4CH Alarm mode setupAlarm Data COMP/VD2/DATA Camera in 1CH Comp S VD2 on Data on Cable compensation/VD2 sync/data setupVS/VD input setup Available channels 1CH, 2CH, 3CH, 4CHCommunication CAM Address Baud Rate Communication setup Camera CommunicationCamera Config CAM no 1CH 2CH 3CH 4CH Not USE Disabled System setup Camera Communication ProtocolAvailable delay times ms OFF, 10, 20, 40 CAM Address Camera 1CH 2CH 3CH 4CHAlarm Data AUTO2 Alarm Camera Selection Alarm OperationOperation Manual resetting Alarm ResetAlarm Suspension External resettingSpecifications Standard Accessories ALL ResetPanasonic Canada Inc