Panasonic WJ-MP204C manual Preface, Features

Page 5

PREFACE

The Data Multiplex Unit WJ-MP204C is designed for instal- lation in a surveillance system, offering system flexibility particularly when camera control functions are required.

The unit multiplexes video signals with control data and VD2 sync into a coaxial cable. This makes installations between the unit and cameras easy.

The monitor and system controller can be located distant from the camera site thanks to the use of a coaxial cable and an RS-485 cable.

The unit includes two protocols, Panasonic Security Data (PS • Data) and the Camera Communication one, selectable with DIP switches.

FEATURES

Front Panel Operations

•Camera channel selection from 1 to 4

•Alarm reset/suspension

•WJ-MP204C setup menus

In/Out Features

•Four camera inputs with multiplexed control and VD2

•Four camera outputs looped through

•Spot (monitor) in/out

•VS/VD (sync) in/out

•RS-485 for use of the Camera Communication Protocol

•RS-485 for use of the PS • Data protocol

•Alarm in/out and remote in/out, switchable

Displayed Image on the monitor screen

•Camera channel selected

•Alarm channel activated

•Setup menus

Camera control with WV-CU360C

•Pan/tilt head and housing control

•Motorized lens control (focus, zoom, iris, etc.)

•Camera setup menus

Alarm Function

•Inputs: Video Motion Detection by the camera/Alarm input to the terminal.

•Output: Signal is supplied to respective alarm terminal.

•Preset: The camera moves to the preset position when an alarm operates.

•Display: The activated channel picture and the channel number are displayed.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Operating Instructions English Version Important Safety Instructions Contents Preface FeaturesDo not drop metallic parts through slots PrecautionsDo not attempt to disassemble the appliance Handle the appliance with careFront View Rear View Mounting in the Rack InstallationMounting One WJ-MP204C with the WV-Q204/1 Mounting two WJ-MP204Cs with the WV-Q204/2Basic Connection PS Data Connection & SettingCamera Site Control SiteCamera Site UnitMultiConnection PS DataMode Video Multiplexer Connection PS DataWV-CU50 Digital Disk Recorder Connection PS DataWJ-MP204C Matrix Switcher Connection Camera CommunicationUnit Number Setting DIP Switch SettingSetting the unit number OFFPS Data Alarm/Remote Terminal SettingCamera Communication Protocol Camera IN/OUTRS-485 Data Port Connection PS Data Internal SettingRS-485 Terminal Connection Camera Communication Internal Diagram Line Half DuplexBasic Connection Daisy ConnectionPrior to setup Setup ProceduresButtons used in the setup WJ-MP204C Setup MENUX.XX Communication SystemSetup menus Communication setup PS Data Setup Menus for PS DataSystem setup PS Data Communication Unit Address Baud RateAlarm CAM no PRE 1CH 2CH 3CH 4CH Alarm mode setupAlarm Data VS/VD input setup Cable compensation/VD2 sync/data setupCOMP/VD2/DATA Camera in 1CH Comp S VD2 on Data on Available channels 1CH, 2CH, 3CH, 4CHCommunication CAM Address Baud Rate Communication setup Camera CommunicationCamera Config CAM no 1CH 2CH 3CH 4CH Available delay times ms OFF, 10, 20, 40 System setup Camera Communication ProtocolNot USE Disabled CAM Address Camera 1CH 2CH 3CH 4CHAlarm Data AUTO2 Alarm Camera Selection Alarm OperationOperation Alarm Suspension Alarm ResetManual resetting External resettingSpecifications ALL Reset Standard AccessoriesPanasonic Canada Inc
Top Page Image Contents