Panasonic WJ-MP204C manual Precautions, Do not drop metallic parts through slots

Page 6

PRECAUTIONS

Refer all work related to the installation of this product to qualified service personnel or system installers.

Do not block the ventilation opening or slots on the cover.

To prevent the appliance temperature from rising, place the appliance at least 5 cm (2 inches) away from the wall.

Do not drop metallic parts through slots.

This could permanently damage the appliance. Turn the power off immediately and refer servicing to quali- fied service personnel.

Do not attempt to disassemble the appliance.

To prevent electric shock, do not remove screws or covers.

There are no user-serviceable parts inside. Refer main- tenance to qualified service personnel.

Handle the appliance with care.

Do not strike or shake, as this may damage the appli- ance.

Do not expose the appliance to water or moisture, nor try to operate it in wet areas.

Do take immediate action if the appliance becomes wet. Turn the power off and refer servicing to qualified service personnel. Moisture can damage the appliance and also cause electric shock.

Do not use strong or abrasive detergents when cleaning the appliance body.

Use a dry cloth to clean the appliance when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe gently.

Do not operate the appliance beyond its specified temperature, humidity or power source ratings.

Do not use the appliance in an extreme environment where high temperature or high humidity exists.

Use the appliance at temperatures within –10°C - +50°C (14°F - 122°F) and a humidity below 90 %.

The input power source for this appliance is 120 V AC 60 Hz.

6

Image 6
Contents Operating Instructions English Version Important Safety Instructions Contents Features PrefaceDo not attempt to disassemble the appliance PrecautionsDo not drop metallic parts through slots Handle the appliance with careFront View Rear View Mounting One WJ-MP204C with the WV-Q204/1 InstallationMounting in the Rack Mounting two WJ-MP204Cs with the WV-Q204/2Camera Site Connection & SettingBasic Connection PS Data Control SiteUnitMultiConnection PS Data Camera SiteVideo Multiplexer Connection PS Data ModeDigital Disk Recorder Connection PS Data WV-CU50Matrix Switcher Connection Camera Communication WJ-MP204CSetting the unit number DIP Switch SettingUnit Number Setting OFFCamera Communication Protocol Alarm/Remote Terminal SettingPS Data Camera IN/OUTInternal Setting RS-485 Data Port Connection PS DataBasic Connection Internal Diagram Line Half DuplexRS-485 Terminal Connection Camera Communication Daisy ConnectionButtons used in the setup Setup ProceduresPrior to setup WJ-MP204C Setup MENUX.XX Communication SystemSetup menus System setup PS Data Setup Menus for PS DataCommunication setup PS Data Communication Unit Address Baud RateAlarm mode setup Alarm DataAlarm CAM no PRE 1CH 2CH 3CH 4CH COMP/VD2/DATA Camera in 1CH Comp S VD2 on Data on Cable compensation/VD2 sync/data setupVS/VD input setup Available channels 1CH, 2CH, 3CH, 4CHCommunication setup Camera Communication Camera Config CAM no 1CH 2CH 3CH 4CHCommunication CAM Address Baud Rate Not USE Disabled System setup Camera Communication ProtocolAvailable delay times ms OFF, 10, 20, 40 CAM Address Camera 1CH 2CH 3CH 4CHAlarm Data AUTO2 Alarm Alarm Operation OperationCamera Selection Manual resetting Alarm ResetAlarm Suspension External resettingSpecifications Standard Accessories ALL ResetPanasonic Canada Inc