Panasonic WJ-MP204C manual DIP Switch Setting, Unit Number Setting, Setting the unit number, Off

●DIP Switch Setting

A 6-bit DIP switch mounted on the rear panel specifies communication mode and sync setup. The default position is marked with an asterisk * in the table below.

Bit 1 specifies the setup for synchronization. Refer to page 23 VS/VD IN and OUT for details. Bit 2 is reserved.

Bit 3 specifies the communication protocol used in the system. Bit 4 is reserved.

Bit 5 specifies the termination in the communication chain.

Bit 6 specifies RS-485 communication mode conducted via DATA port or RS-485 terminal. Set it to 4-line when PS • Data is used.

OFF

1

2

3

4

5

6

ON

Function

SW position

OFF

ON

Bit 1

Sync setup

THROUGH*

VS/VD

Bit 2

Reserved

Fixed to OFF*

Not used

Bit 3

Protocol

PS • Data*

Camera Communication

Bit 4

Reserved

Fixed to OFF*

Not used

Bit 5

Line termination

Off

On*

Bit 6

RS-485 mode

4-line full duplex*

2-line half duplex

●Unit Number Setting

A rotary switch is placed on the front panel. It specifies the WJ-MP204C unit number in a PS • Data protocol system, or camera unit numbers in a Camera Communication Protocol system.

8Setting the unit number

1Turn off the power switch of the unit.

2Use a screw driver to rotate the UNIT switch so that the arrow comes to the number you wish.

3Turn on the power switch.

UNIT

9

8 7

6

0 1

	2
	3
5	4

Notes:

•The unit number can be specified in the setup menu when the UNIT switch is set to "0."

•Position #9 is not allowed to be set, because it is reserved.

•Specify a unique number for each unit when connecting more than one unit in a data communication chain.

15