Panasonic WJ-MP204C manual Standard Accessories, ALL Reset

Page 31

STANDARD ACCESSORIES

Switch Protector

1 pc.

ALL RESET

The Data Multiplex Unit WJ-MP204C can be reset to the default settings as follows:

1.Press the power switch to set it to the OFF position.

2.Press the power switch down to the ON position while pressing the camera selection buttons 2, 3, and 4.

3.Continue to press the camera selection button approximately 3 seconds after pressing the power switch down to the ON position.

4.When all indicators light up, resetting is completed.

Press

Image 31

Contents Operating Instructions English Version Important Safety Instructions Contents Preface FeaturesHandle the appliance with care PrecautionsDo not drop metallic parts through slots Do not attempt to disassemble the applianceFront View Rear View Mounting two WJ-MP204Cs with the WV-Q204/2 InstallationMounting in the Rack Mounting One WJ-MP204C with the WV-Q204/1Control Site Connection & SettingBasic Connection PS Data Camera SiteCamera Site UnitMultiConnection PS DataMode Video Multiplexer Connection PS DataWV-CU50 Digital Disk Recorder Connection PS DataWJ-MP204C Matrix Switcher Connection Camera CommunicationOFF DIP Switch SettingUnit Number Setting Setting the unit numberCamera IN/OUT Alarm/Remote Terminal SettingPS Data Camera Communication ProtocolRS-485 Data Port Connection PS Data Internal SettingDaisy Connection Internal Diagram Line Half DuplexRS-485 Terminal Connection Camera Communication Basic ConnectionWJ-MP204C Setup MENUX.XX Communication System Setup ProceduresPrior to setup Buttons used in the setupSetup menus Communication Unit Address Baud Rate Setup Menus for PS DataCommunication setup PS Data System setup PS DataAlarm Data Alarm mode setupAlarm CAM no PRE 1CH 2CH 3CH 4CH Available channels 1CH, 2CH, 3CH, 4CH Cable compensation/VD2 sync/data setupVS/VD input setup COMP/VD2/DATA Camera in 1CH Comp S VD2 on Data onCamera Config CAM no 1CH 2CH 3CH 4CH Communication setup Camera CommunicationCommunication CAM Address Baud Rate CAM Address Camera 1CH 2CH 3CH 4CH System setup Camera Communication ProtocolAvailable delay times ms OFF, 10, 20, 40 Not USE DisabledAlarm Data AUTO2 Alarm Operation Alarm OperationCamera Selection External resetting Alarm ResetAlarm Suspension Manual resettingSpecifications ALL Reset Standard AccessoriesPanasonic Canada Inc