Panasonic WJ-MP204C manual Panasonic Canada Inc

Page 32

Panasonic Security and Digital Imaging Company

A Division of Matsushita Electric Corporation of America

Executive Office: One Panasonic Way 3E-7, Secaucus, New Jersey 07094

Regional Offices:

Northeast: One Panasonic Way, Secaucus, NJ 07094 (201) 348-7303

Southern: 1225 Northbrook Parkway, Suite 1-160, Suwanee, GA 30024 (770) 338-6838

Midwest: 1707 North Randall Road, Elgin, IL 60123 (847) 468-5211

Western: 6550 Katella Ave., Cypress, CA 90630 (714) 373-7840

Panasonic Canada Inc.

5770 Ambler Drive, Mississauga, Ontario, L4W 2T3 Canada (905)624-5010

Panasonic Sales Company

Division of Matsushita Electric of Puerto Rico Inc.

Ave. 65 de Infanteria. Km. 9.5

San Gabriel Industrial Park, Carolina,

Puerto Rico 00985 (809)750-4300

N1001-0	V8QA5877AN	Printed in Japan
		N 19

Image 32

Contents Operating Instructions English Version Important Safety Instructions Contents Features PrefacePrecautions Do not drop metallic parts through slotsDo not attempt to disassemble the appliance Handle the appliance with careFront View Rear View Installation Mounting in the RackMounting One WJ-MP204C with the WV-Q204/1 Mounting two WJ-MP204Cs with the WV-Q204/2Connection & Setting Basic Connection PS DataCamera Site Control SiteUnitMultiConnection PS Data Camera SiteVideo Multiplexer Connection PS Data ModeDigital Disk Recorder Connection PS Data WV-CU50Matrix Switcher Connection Camera Communication WJ-MP204CDIP Switch Setting Unit Number SettingSetting the unit number OFFAlarm/Remote Terminal Setting PS DataCamera Communication Protocol Camera IN/OUTInternal Setting RS-485 Data Port Connection PS DataInternal Diagram Line Half Duplex RS-485 Terminal Connection Camera CommunicationBasic Connection Daisy ConnectionSetup Procedures Prior to setupButtons used in the setup WJ-MP204C Setup MENUX.XX Communication SystemSetup menus Setup Menus for PS Data Communication setup PS DataSystem setup PS Data Communication Unit Address Baud RateAlarm CAM no PRE 1CH 2CH 3CH 4CH Alarm mode setupAlarm Data Cable compensation/VD2 sync/data setup VS/VD input setupCOMP/VD2/DATA Camera in 1CH Comp S VD2 on Data on Available channels 1CH, 2CH, 3CH, 4CHCommunication CAM Address Baud Rate Communication setup Camera CommunicationCamera Config CAM no 1CH 2CH 3CH 4CH System setup Camera Communication Protocol Available delay times ms OFF, 10, 20, 40Not USE Disabled CAM Address Camera 1CH 2CH 3CH 4CHAlarm Data AUTO2 Alarm Camera Selection Alarm OperationOperation Alarm Reset Alarm SuspensionManual resetting External resettingSpecifications Standard Accessories ALL ResetPanasonic Canada Inc