Panasonic WJ-MP204C Connection & Setting, Basic Connection PS Data, Camera Site, Control Site

CONNECTION & SETTING

Shown below are some system connection examples using Data Multiplex unit with peripheral devices in PS • Data (Panasonic Security Data) or the Camera Communication Protocols. Note that all system devices in a system should use the same proto- col.

●Basic Connection (PS • Data)

Up to four cameras are connected with the unit at a camera site while a System Controller operates camera selection, pan/tilt and lens control at a control site.

Camera

4 ch

1 ch

2 ch

3 ch

Camera Site

IN	4	3	2	1	IN	IN	ALARM / REMOTE
Monitor							T	R
							G B A B	A	SIGNAL GND
OUT	4	3	2	1	OUT	OUT
		CAMERA			SPOT	VS/VD	RS485	DATA	MODE

Termination ON

Controller No. 1

OPERATE	LOGIN	ALARM	MONITOR	CAMERA	BUSY PROHIBITED
			UNIT
					System Controller WV-CU 360

	PROGRAM
SETUP	CAM SETUP	IRIS
	CLOSE	OPEN

SHIFT	FUNCTION	CAM FUNCTION		IRIS RESET	UP
ALM RESET	ALM SUSPEND	AUTO	UNIT A	FOCUS

NEAR FAR

ALM RECALL		B/W	UNIT	AUTO FOCUS
VTR CAM	MULTI SCREEN SELECT	DEF		L	R
			UNIT B	ZOOM

		AUX 2	TELE
STILL	EL-ZOOM	WIDE
		WIPER

DOWN

	–	+	AUX 1
SEQ PAUSE		SEQUENCE	PATROL PLAY	MON	CAM	HOME/PRESET

MODE

System Controller WV-CU360C

4-Line Termination ON

Panasonic Security Data mode

SLOW	PATROL	PATROL	ESC LOGOUT SET	PROGRAM
	STOP	LEARN		PRESET

Control Site

Video signal

RS485 signal

(Panasonic Security Data mode)

10