If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces.
•Failure to observe this may cause the user to absorb the gas which was released when the lamp broke and which contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces may cause injury.
•If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical advice immediately.
•Ask your dealer about the replacement of the lamp unit and check the inside of the projector.
If not using the projector for an extended period of time, disconnect the power cord plug from the mains socket.
•If dust builds up on the power cord plug, the resulting humidity may damage the insulation, which could result in fire.
Disconnect the power cord plug from the wall outlet as a safety precaution before carrying out any cleaning.
• Electric shocks can result if this is not done.
Be careful not to catch your fingers between the lens and shroud when shifting the lens.
• Do not catch your fingers between the lens and shroud when shifting the lens as it may cause injury.
Ask an Authorized Service Centre to clean inside the projector at least once a year.
•If dust is left to build up inside the projector without being cleaned out, it can result in fire or problems with operation.
•It is a good idea to clean the inside of the projector before the season for humid weather arrives. Ask your nearest Authorized Service Centre to clean the projector when required. Please discuss with the Authorized Service Centre regarding cleaning costs.
If not using the projector for an extended period of time, remove the batteries from the remote control.
•Failure to do so may cause the batteries to leak, overheat, catch fire or explode, possibly resulting in fire or corruption of surrounding areas.
Do not use the old lamp unit.
• The lamp section may break.
Do not place the projector in extremely hot locations.
•Doing so may cause the outer casing or internal components to deteriorate, or result in fire.
•Take particular care in locations exposed to direct sunlight or near stoves.
Accessories
Check that all of the accessories shown below have been included with your projector.
ENGLISH
Remote control unit [N2QAYB000164 x 1]
Power cord for U.K. [K2CT3FZ00003 x 1]
for Continental [K2CM3FZ00003 x 1]
Battery for remote control unit (AA) [R6DW/2ST]
Lens cover
Sefety cable [TTRA0146]
Wire cable (x 1)
Wire fastening M6 (Length:10 mm) screw (x 1)
7