Front and side of the projector
Status LED lights (Refer to the figure on the right.)
Status LED lights
AC IN terminal (page 22)
Connect the supplied line power cord into this receptacle.
Do not connect any other cable to this socket.
Air filter (page 54)
Security lock
Attach a commercial burglar prevention cable (e.g., from Kensington) to this lock port. It is compatible with the Microsaver Security System from Kensington.
Anti-theft hook
Attach a chain or other fastening device available from a hardware store through this clamp.
Level-adjusting feet (page 22)
Use these feet to adjust the tilt of the projector. (The leveling feet at the front left and right can be adjusted.)
Lens release button (page 24)
Press this to remove the projection lens.
Projection lens
Lens for projecting images on the screen.
Lens left/right adjusting dial (page 25)
Turn this clockwise to move the screen to the left; conversely, turn it counterclockwise to move it to the right.
Remote control receiver window (front) (page 14)
This window receives the signal beam emitted from the remote control.
Focus ring (page 24)
For focus adjustment.
Powered focus adjustment is also available.
Temperature monitor (TEMP) (page 53)
Lighting or blinking of this lamp indicates an abnormal condition of the internal temperature.
LAMP1 monitor (page 53)
This lamp lights up when the time to replace lamp unit 1 is reached. It also blinks if something unusual occurs in the lamp circuit.
LAMP2 monitor (page 53)
This lamp lights up when the time to replace lamp unit 2 is reached. It also blinks if something unusual occurs in the lamp circuit.
Power indicator (pages 22, 53)
The lamp lights in red when the MAIN POWER switch is turned to “l” (on). It turns to green when the POWER ON button of the remote control or the main unit is pressed.
Lens cap
Cap the lens whenever the projector is left unused.
Air intake vents
Attention • Do not remove the upper cover (white or black top panel).
ENGLISH
11