Name and function of parts
Remote control
Remote control operation indicator lamp
The lamp flashes when any remote control button is pressed.
POWER STANDBY ( 
) button (page 23)
Switched the power to the “standby” mode if the MAIN POWER has been put to the “l” position.
POWER ON ( I ) button (page 22)
Turns on the power if the MAIN POWER has been put to the “l” position.
Input selector (RGB1, RGB2,
Use to toggle through the RGB1, RGB2,
MENU button (page 27)
Displays and clears the MAIN MENU. It can also return to the previous screen when the menu is displayed.
Arrow 
buttons (page 27)
Use these buttons to select an item on the menu screen, change setting and adjust the level.
Also use them to enter the “SECURITY” password.
ENTER button (page 27)
Press this button to enter your menu selection or to run function.
ON SCREEN button
This button turns on and off the
TEST PATTERN button (page 38)
This displays the test pattern.
Numeric (0 - 9) buttons (pages 15, 38)
These buttons are used for systems where more than one projector is being used.
They are used to enter ID numbers when selecting an ID, and they are also used by service personnel for entering passwords when password entry is needed.
STATUS button (page 25)
Press this button to display projector information. It can also be used to send information about the projector’s status via
AUTO SETUP button (page 25)
Pressing this button while projecting an image automatically corrects the picture positioning on the screen. While the auto setup feature is active, a message “AUTO SETUP” appears on the screen.
SHUTTER button (page 25)
Press this button to black out the image temporarily.
ASPECT button (page 29)
Switches the image aspect ratio.
ENGLISH
9