Error information page
When 
is displayed on the status information screen, click it to display the error details.
OK: Normal operation
FAILED: Occurrence of trouble
Note • Depending on the nature of the error, the projector may be placed in the standby mode for its own protection.
When [FAILED] has appeared for an item
Parameter | Description | |
|
| |
MAIN CPU BUS | Trouble has occurred in the microcomputer circuitry. Consult your dealer. | |
FAN | Trouble has occurred in the fan or its drive circuit. Consult your dealer. | |
OPTICS MODULE | The temperature inside the projector is high. | |
It may be that the projector is being used where the ambient temperature is | ||
TEMPERATURE | ||
high such as near a heating appliance. | ||
| ||
INPUT AIR TEMPERATURE | The input air temperature is too high. | |
It may be that the projector is being used where the ambient temperature is | ||
| high such as near a heating appliance. | |
AROUND LAMP | The temperature near the lamp has risen very high. | |
TEMPERATURE | Something may be blocking the exhaust vent. | |
LAMP REMAIN TIME | The lamp runtime has exceeded the prescribed cumulative time, and it is | |
now time to replace the lamp. | ||
| ||
LAMP STATUS | The lamp has failed to light. | |
Wait a short while for the lamp to cool off, and then turn on the power. | ||
| ||
SHUTTER | Trouble has occurred in the shutter circuitry. Consult your dealer. | |
AIR FILTER | Too much dust accumulates on the air filter. | |
Turn off the MAIN POWER switch using the procedure on page 23 and | ||
| clean the air filter (refer to page 54). | |
OPTICS MODULE TEMP.SENSOR | Trouble has occurred in the temperature detection sensor inside the | |
projector. Consult your dealer. | ||
| ||
INPUT AIR TEMP.SENSOR | Trouble has occurred in the sensor used to detect the input air temperature. | |
Consult your dealer. | ||
| ||
AROUND LAMP | Trouble has occurred in the temperature detection sensor around lamps. | |
TEMP. SENSOR | Consult your dealer. | |
BATTERY | The backup battery has been run out. Consult your dealer. | |
AIRFLOW SENSOR | Trouble has occurred in the air volume sensor. Consult your dealer. | |
COLOR WHEEL | Trouble has occurred in the colour wheel or the colour wheel drive circuit. | |
Consult your dealer. | ||
˜ | ||
The lamp unit cover is not properly fitted. Check the fitting of the lamp unit | ||
COVER OPEN | ||
cover. (page 56) | ||
| ||
|
|
ENGLISH
43