MGE UPS Systems 4000 RT user manual Installation in rack position

Page 14

2. Installation

2.4 Installation in rack position

Adjustment of the orientation of the logo and control panel

UPS module rack mounting (optional rails required)

Pulsar MX RT is very heavy. To ease its rack integration, we strongly recommend to remove the battery tray as shown below:

		4
3	3	1
3		1
		1

x 6

1 - Remove the 6 fixing screws to free the main front panel bezel.

2 - Place the front panel above the UPS.

3 - Remove the 4 fixing screws on the right side to free the battery sub-module. 4 - Pull the battery sub-module slightly, then lift it to extract it.

34008030EN/AA - Page 14

Image 14

Contents Pulsar MX 34008030EN/AA Substances IntroductionEnvironmental protection PackingPictograms Contents Troubleshooting Technical specifications GlossaryStandard positions Dimensions H x W x D in mm / InchesPresentation Tower position Rack positionPulsar MX 4000 RT / 5000 RT Pulsar MX EXB RT optional battery moduleRear panels Rack mounting kit Display and control panelOptions Telescopic rails, 639 mm to 1005 mmPulsar MX RT ModularEasyPulsar MX RT Pulsar MX RT ModularEasy Battery extensions for Pulsar MX RT Battery Integration SystemBattery extension cable 1,8 m / 6 ft Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 minInternal battery connection Battery start-up InstallationUnpacking and contents check Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Connection to the communication port by relays Communication portsConnection to the RS 232 communication port Remote power off contact normally closed Remote Power Off communication portRemote power off contact normally open Recommended downstream protection Required protective devices and cable cross-sectionsRecommended upstream protection Required cable cross-sectionsConnection of input/output power cables on UPS terminals Always connect first the earthing wireConnection of IEC cables to output receptacles Final start-up sequence OperationInitial start-up UPS personalisationEquipments are supplied in ECO mode Normal modeEco mode Operating modesLow battery warning Operation on battery powerTransfer to battery power End of backup timeUPS shutdown Press the 0 button 28 more than 3sMaintenance menu Access to measurements and personalisation dataAccess to measurements Display organisationON/OFF settings Local settingsOutput settings UPS set-upBattery settings MaintenancePersonalisation using external software But the operation is downgraded TroubleshootingTroubleshooting Leds 21 By the UPSIndication Diagnostic Correction Display Signification CorrectionDescription Secure your installation power continuityLife Cycle Monitoring LCM Get free offersReset or disable LCM Hot swapping the battery sub-module MaintenanceHot swapping the power sub-module Return to normal operation Reconnecting the battery sub-moduleMaintenance Test positionTraining centre Hz training centreTechnical specifications AppendicesGlossary 34008030EN/AA 34008030EN/AA