MGE UPS Systems 4000 RT user manual Operating modes, Normal mode, Eco mode

Page 22

3. Operation

3.3 Operating modes

Normal mode

ESC

I O

30 32 34

Eco mode

ESC

I O

32 34

20 21

ESC

I O

30 32 34

This is the standard operating mode, set by default in the factory.

Under normal condition (Normal AC source available):

LED (20) is ON.

LEDs (30), (32), (34) are green.

The equipments are protected by the UPS.

The main advantage of the Eco mode (see glossary) is that it reduces the consumption of electrical power.

Under normal condition (Normal AC source available):

LED (20) is ON.

LEDs (32), (34) are green.

The equipments are supplied in ECO mode.

If normal AC source is out of tolerance: LEDs (20), (21) are ON.

LEDs (30), (32), (34) are green.

The equipments are protected by the UPS.

34008030EN/AA - Page 22

Image 22

Contents Pulsar MX 34008030EN/AA Substances IntroductionEnvironmental protection PackingPictograms Contents Troubleshooting Technical specifications GlossaryStandard positions Dimensions H x W x D in mm / InchesPresentation Tower position Rack positionRear panels Pulsar MX EXB RT optional battery modulePulsar MX 4000 RT / 5000 RT Rack mounting kit Display and control panelOptions Telescopic rails, 639 mm to 1005 mmPulsar MX RT Pulsar MX RT ModularEasy ModularEasyPulsar MX RT Battery extensions for Pulsar MX RT Battery Integration SystemBattery extension cable 1,8 m / 6 ft Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 minUnpacking and contents check InstallationInternal battery connection Battery start-up Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Connection to the RS 232 communication port Communication portsConnection to the communication port by relays Remote power off contact normally open Remote Power Off communication portRemote power off contact normally closed Recommended downstream protection Required protective devices and cable cross-sectionsRecommended upstream protection Required cable cross-sectionsConnection of input/output power cables on UPS terminals Always connect first the earthing wireConnection of IEC cables to output receptacles Final start-up sequence OperationInitial start-up UPS personalisationEquipments are supplied in ECO mode Normal modeEco mode Operating modesLow battery warning Operation on battery powerTransfer to battery power End of backup timeUPS shutdown Press the 0 button 28 more than 3sMaintenance menu Access to measurements and personalisation dataAccess to measurements Display organisationON/OFF settings Local settingsOutput settings UPS set-upPersonalisation using external software MaintenanceBattery settings But the operation is downgraded TroubleshootingTroubleshooting Leds 21 By the UPSIndication Diagnostic Correction Display Signification CorrectionDescription Secure your installation power continuityLife Cycle Monitoring LCM Get free offersReset or disable LCM Hot swapping the power sub-module MaintenanceHot swapping the battery sub-module Return to normal operation Reconnecting the battery sub-moduleMaintenance Test positionTraining centre Hz training centreTechnical specifications AppendicesGlossary 34008030EN/AA 34008030EN/AA