MGE UPS Systems 4000 RT user manual UPS or battery module rack mounting optional rails required

Page 15

2. Installation

UPS or battery module rack mounting (optional rails required)

It is not allowed to install the UPS or battery module in a hermetically closed environment without any exchange of air.

Follow steps 1 to 4 for rack mounting the UPS onto the rails.

1 4

The rails and the necessary mounting hardware are supplied by MGE UPS SYSTEMS.

Note for step 1: it is possible to adjust the position of both front mounting ears.

Rear bracket system (included with rail kits)

To be used if you need to move the rack enclosure with UPS already rack-mounted inside.

34008030EN/AA - Page 15

Image 15

Contents Pulsar MX 34008030EN/AA Packing IntroductionEnvironmental protection SubstancesPictograms Contents Technical specifications Glossary TroubleshootingTower position Rack position Dimensions H x W x D in mm / InchesPresentation Standard positionsPulsar MX EXB RT optional battery module Rear panelsPulsar MX 4000 RT / 5000 RT Telescopic rails, 639 mm to 1005 mm Display and control panelOptions Rack mounting kitModularEasy Pulsar MX RT Pulsar MX RT ModularEasyPulsar MX RT Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 min Battery Integration SystemBattery extension cable 1,8 m / 6 ft Battery extensions for Pulsar MX RTInstallation Unpacking and contents checkInternal battery connection Battery start-up Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Communication ports Connection to the RS 232 communication portConnection to the communication port by relays Remote Power Off communication port Remote power off contact normally openRemote power off contact normally closed Required cable cross-sections Required protective devices and cable cross-sectionsRecommended upstream protection Recommended downstream protectionAlways connect first the earthing wire Connection of input/output power cables on UPS terminalsConnection of IEC cables to output receptacles UPS personalisation OperationInitial start-up Final start-up sequenceOperating modes Normal modeEco mode Equipments are supplied in ECO modeEnd of backup time Operation on battery powerTransfer to battery power Low battery warningPress the 0 button 28 more than 3s UPS shutdownDisplay organisation Access to measurements and personalisation dataAccess to measurements Maintenance menuUPS set-up Local settingsOutput settings ON/OFF settingsMaintenance Personalisation using external softwareBattery settings By the UPS TroubleshootingTroubleshooting Leds 21 But the operation is downgradedDisplay Signification Correction Indication Diagnostic CorrectionGet free offers Secure your installation power continuityLife Cycle Monitoring LCM DescriptionReset or disable LCM Maintenance Hot swapping the power sub-moduleHot swapping the battery sub-module Test position Reconnecting the battery sub-moduleMaintenance Return to normal operationHz training centre Training centreAppendices Technical specificationsGlossary 34008030EN/AA 34008030EN/AA