MGE UPS Systems 4000 RT user manual Connection of IEC cables to output receptacles

Page 20

2. Installation

2.8 Connection of IEC cables to output receptacles

2

44

49

1

3

1 - Connect the equipments to the UPS using the cables (49).

It is preferable to connect the priority equipments to the four outlets (2) and the non priority equipments to the four outlets (1) that can be programmed in pairs (1 and 2). Connect any high-power devices to the 16 A outlet (3)

To program shutdown of outlets (2) during operation on battery power and thus optimise the available backup time, the MGE UPS SYSTEMS communication software is required.

2 - Fit the connection securing system (44) that prevents the plugs from being pulled out accidentally.

34008030EN/AA - Page 20

Image 20

Contents Pulsar MX 34008030EN/AA Introduction Environmental protectionSubstances PackingPictograms Contents Troubleshooting Technical specifications GlossaryDimensions H x W x D in mm / Inches PresentationStandard positions Tower position Rack positionPulsar MX 4000 RT / 5000 RT Pulsar MX EXB RT optional battery moduleRear panels Display and control panel OptionsRack mounting kit Telescopic rails, 639 mm to 1005 mmPulsar MX RT ModularEasyPulsar MX RT Pulsar MX RT ModularEasy Battery Integration System Battery extension cable 1,8 m / 6 ftBattery extensions for Pulsar MX RT Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 minInternal battery connection Battery start-up InstallationUnpacking and contents check Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Connection to the communication port by relays Communication portsConnection to the RS 232 communication port Remote power off contact normally closed Remote Power Off communication portRemote power off contact normally open Required protective devices and cable cross-sections Recommended upstream protectionRecommended downstream protection Required cable cross-sectionsConnection of input/output power cables on UPS terminals Always connect first the earthing wireConnection of IEC cables to output receptacles Operation Initial start-upFinal start-up sequence UPS personalisationNormal mode Eco modeEquipments are supplied in ECO mode Operating modesOperation on battery power Transfer to battery powerLow battery warning End of backup timeUPS shutdown Press the 0 button 28 more than 3sAccess to measurements and personalisation data Access to measurementsMaintenance menu Display organisationLocal settings Output settingsON/OFF settings UPS set-upBattery settings MaintenancePersonalisation using external software Troubleshooting Troubleshooting Leds 21But the operation is downgraded By the UPSIndication Diagnostic Correction Display Signification CorrectionSecure your installation power continuity Life Cycle Monitoring LCMDescription Get free offersReset or disable LCM Hot swapping the battery sub-module MaintenanceHot swapping the power sub-module Reconnecting the battery sub-module MaintenanceReturn to normal operation Test positionTraining centre Hz training centreTechnical specifications AppendicesGlossary 34008030EN/AA 34008030EN/AA