MGE UPS Systems 4000 RT Access to measurements and personalisation data, Display organisation

Page 25

4.Access to measurements and personalisation data

4.1Display organisation

Status and Alarms

Measurements

UPS input measurements

UPS output measurements

Battery measurements

UPS Set-up

Maintenance

Local settings

Output settings

ON/OFF settings

Battery settings

Model

Alarm History

Manual batt test

Led & Buzzer test

LCM

Statistics

Operation limits

4.2 Access to measurements

Press the scroll button (24) (see section 1.3, page 9) to access measurements for voltage, current, frequency, power output and battery capacity.

4.3Access to UPS set-up and maintenance using the control panel (23)

◗Press the scroll button (25) a number of times to point the UPS set-upor

Maintenance menu

◗ Press the Enter button (27) to get access.

UPS SET-UP
MAINTENANCE	23
ESC	25
	25
	27

I O

34008030EN/AA - Page 25

Image 25

Contents Pulsar MX 34008030EN/AA Environmental protection IntroductionSubstances PackingPictograms Contents Technical specifications Glossary TroubleshootingPresentation Dimensions H x W x D in mm / InchesStandard positions Tower position Rack positionRear panels Pulsar MX EXB RT optional battery modulePulsar MX 4000 RT / 5000 RT Options Display and control panelRack mounting kit Telescopic rails, 639 mm to 1005 mmPulsar MX RT Pulsar MX RT ModularEasy ModularEasyPulsar MX RT Battery extension cable 1,8 m / 6 ft Battery Integration SystemBattery extensions for Pulsar MX RT Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 minUnpacking and contents check InstallationInternal battery connection Battery start-up Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Connection to the RS 232 communication port Communication portsConnection to the communication port by relays Remote power off contact normally open Remote Power Off communication portRemote power off contact normally closed Recommended upstream protection Required protective devices and cable cross-sectionsRecommended downstream protection Required cable cross-sectionsAlways connect first the earthing wire Connection of input/output power cables on UPS terminalsConnection of IEC cables to output receptacles Initial start-up OperationFinal start-up sequence UPS personalisationEco mode Normal modeEquipments are supplied in ECO mode Operating modesTransfer to battery power Operation on battery powerLow battery warning End of backup timePress the 0 button 28 more than 3s UPS shutdownAccess to measurements Access to measurements and personalisation dataMaintenance menu Display organisationOutput settings Local settingsON/OFF settings UPS set-upPersonalisation using external software MaintenanceBattery settings Troubleshooting Leds 21 TroubleshootingBut the operation is downgraded By the UPSDisplay Signification Correction Indication Diagnostic CorrectionLife Cycle Monitoring LCM Secure your installation power continuityDescription Get free offersReset or disable LCM Hot swapping the power sub-module MaintenanceHot swapping the battery sub-module Maintenance Reconnecting the battery sub-moduleReturn to normal operation Test positionHz training centre Training centreAppendices Technical specificationsGlossary 34008030EN/AA 34008030EN/AA