MGE UPS Systems 4000 RT user manual UPS shutdown, Press the 0 button 28 more than 3s

Page 24

3. Operation

3.6 UPS shutdown

ESC

1 - Press the "0" button (28) more than 3s.

The buzzer beeps once, and the load is no longer protected by the UPS. It is powered via the Normal AC source. If the UPS is set in frequency converter mode, the equipments will not be powered.

If the Normal AC source is out of tolerance, the UPS will generate a 10ms output calibrated break.

2 - For a full shutdown of UPS and connected load, the upstream circuit breaker (not included) should be set to the "0" position.

34008030EN/AA - Page 24

Image 24

Contents Pulsar MX 34008030EN/AA Introduction Environmental protectionSubstances PackingPictograms Contents Troubleshooting Technical specifications GlossaryDimensions H x W x D in mm / Inches PresentationStandard positions Tower position Rack positionPulsar MX EXB RT optional battery module Rear panelsPulsar MX 4000 RT / 5000 RT Display and control panel OptionsRack mounting kit Telescopic rails, 639 mm to 1005 mmModularEasy Pulsar MX RT Pulsar MX RT ModularEasyPulsar MX RT Battery Integration System Battery extension cable 1,8 m / 6 ftBattery extensions for Pulsar MX RT Pulsar MX EXB RT Pulsar MX 4000 RT Min 29 min 53 minInstallation Unpacking and contents checkInternal battery connection Battery start-up Installation in tower position Installation in rack position UPS or battery module rack mounting optional rails required Communication ports Connection to the RS 232 communication portConnection to the communication port by relays Remote Power Off communication port Remote power off contact normally openRemote power off contact normally closed Required protective devices and cable cross-sections Recommended upstream protectionRecommended downstream protection Required cable cross-sectionsConnection of input/output power cables on UPS terminals Always connect first the earthing wireConnection of IEC cables to output receptacles Operation Initial start-upFinal start-up sequence UPS personalisationNormal mode Eco modeEquipments are supplied in ECO mode Operating modesOperation on battery power Transfer to battery powerLow battery warning End of backup timeUPS shutdown Press the 0 button 28 more than 3sAccess to measurements and personalisation data Access to measurementsMaintenance menu Display organisationLocal settings Output settingsON/OFF settings UPS set-upMaintenance Personalisation using external softwareBattery settings Troubleshooting Troubleshooting Leds 21But the operation is downgraded By the UPSIndication Diagnostic Correction Display Signification CorrectionSecure your installation power continuity Life Cycle Monitoring LCMDescription Get free offersReset or disable LCM Maintenance Hot swapping the power sub-moduleHot swapping the battery sub-module Reconnecting the battery sub-module MaintenanceReturn to normal operation Test positionTraining centre Hz training centreTechnical specifications AppendicesGlossary 34008030EN/AA 34008030EN/AA