American Power Conversion 208/220 installation manual Stabilizing Brackets,  

Mechanical assembly

Stabilizing Brackets

Always install the Stabilizing Brackets on the 13.85 in/352 mm Enclosure (shipped with the UPS) to enhance the stability of the Enclosure.

Attach the Stabilizing Bracket to the UPS Enclosure re-using the screws used to secure the UPS to the pallet during shipment.

Note



BATTERY UNIT BATTERY UNIT

BATTERY UNIT BATTERY UNIT

BATTERY UNIT BATTERY UNIT

BATTERY UNIT BATTERY UNIT

Stabilizing Bracket



 

If the Enclosure needs to be moved after Stabilizing Brackets have been attached to the Enclosure, the Stabilizing Brackets must be pushed up into their high position.

Loosen the two screws of both Stabilizing Brackets, and push the bracket up into the high position.

When the Enclosure has reached its new position, push the Bracket into its “down” position again, and tighten the screws.

WARNING!

For stability reasons, do not remove Stabilizing Brackets from 13.85 in/352 mm Enclosures.

18 Smart-UPS® VT 10-30 kVA, 208/220 V Site Preparation and Installation Manual 990-1598B