BIXOLON SRP-270 Alignment and Adjustments, Printer Adjustment, Adjustment of Head gap

SRP-270

6. Alignment and Adjustments

6-1 Printer Adjustment

When assembling this printer, be sure to refer to the required adjustment procedure.

To ensure normal operation of the printer after disassembly or replacement of a Component for maintenance or repair. Be sure to perform along to the required method.

* Adjustment of Head gap

Adjustment	Description Points	in Adjustment
Step

1• Rotate Gear lst Reduction to move the Head unit to L side.

2	• Insert the thickness gauge between Head unit and	- Appropriate gap: 0.50~0.60mm
	Platen, then rotate the Ad.
	Level L and adjust the gap.

- In order to make the gap narrow (wide), turn Ad.

Lever to mark ’-(+)’

•Move the Head unit then check if the proper

3 gap from R side center has been achieved.

4	• If Head gap is not proper, adjust Head gap by	- If gap is not correct, repeat once
	rotating Ad.Lever R.
		more.
	(Replacement of Head unit)

Follow below steps for replacing Head unit

1.Loosen the Ribbon frame

2.Disassemble the Head unit from the Head Carriage and take out the Head FPC from the connector of PCB Assy.

4.Replace the Head unit and assemble, according to the order of sub Aassy-1

5.After assembling, adjust the gap as above “Adjustment” indicates.

6.Assemble the Ribbon Frame.

Rev. 3.02 - 45 -